Stimmen - 4, Durchschnittliche Bewertung: 4.5
(
)
)
|
Anleitung Zusammenfassung
. 4. Assurez-vous que la soupape d’arret de la canalisation principale est ouverte. 5. Enfoncez legerement le bouton de reglage du gaz et tournez-le dans le sens des aiguilles d’une montre jusqu’a la position d’arret “OFF”. HI LOW TPTH TP TH PILOT PILOTON ti OFF OUTIN 1. Tournez l’interrupteur mural a la position d’arret “OFF”. La veilleuse restera allumee jusqu’au retour du service normal. 2. Pour une fermeture complete, tournez l’interrupteur mural a la position d’arret “OFF”. 3. Ouvrez le compartiment de controle du bas. POUR FERMER LE GAZ QUI ALIMENTE L’APPAREIL 4. Enfoncez legerement le bouton de reglage du gaz et tournez-le dans le sens des aiguilles d’une montre jusqu’a la position d’arret “OFF”. Ne forcez pas le bouton. 5. Fermez le compartiment de controle du bas. REMARQUE : LES SCHEMAS ET LES ILLUSTRATIONS NE SONT PAS A L’ECHELLE SUPERIORSUPERIORDIRECT-VENT GAS FIREPLACES • MODELS SLDVT-30/35/40/45 • CARE AND OPERATION INSTRUCTIONS LIGHTING INSTRUCTIONS — ELECTRONIC A. When lighting the appliance, follow these instructions exactly. B. BEFORE OPERATING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor. WHAT TO DO IF YOU SMELL GAS •Extinguish any open flame. •Open windows. •Do not light any appliance. •Do not touch any electrical switches. FOR YOUR SAFETY READ BEFORE LIGHTING •Do not use any phone in your building. •Immediately call your gas supplier from a neighbor’s phone. •If your gas supplier cannot be reached, call the fire department. C. Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water. WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. LIGHTING INSTRUCTIONS 1. STOP! Read the safety information above on this page. 2. Turn remote wall switch to “OFF" or set wall thermostat to lowest setting. If used, remove the batteries from the battery holder. 3. This appliance is equipped with an ignition device which automatically lights the pilot. Do not try to light the pilot by hand. 4. Push the unit mounted "ON/OFF" switch to the "OFF" position. 6. Push the unit mounted "ON/OFF" switch back to the "ON" position. (The "ON/OFF" switch may include a wall switch if so equipped). Replace the batteries in the battery holder, if used. If the burner does not light or stay lit after several tries, turn the unit mounted "ON/OFF" switch to the "OFF" position and call your service technician or gas supplier. NOTE: Sufficient time must be allowed for air to escape from lines if the unit is being lit for the first time. 7. Turn HI-LO burner control knob to desired setting and close control door. PILOTOUTVENTLOTHTPTHTPHIININ 5. Allow sufficient length of time (minimum 5 minutes) for any gas in t...
Dieses Handbuch ist für folgende Modelle:Kamine - SLDVT-30NE (2.16 mb)
Kamine - SLDVT-30NE (2.16 mb)
Kamine - SLDVT-30NE (2.16 mb)
Kamine - SLDVT-30NE (2.16 mb)