This is not common, but it does happen. Practice on scrap materials first to see how the Moto-Tool cuts. Keep in mind that the work']s done by the speed of the tool and by the accessory in the chuck. You should not lean on or push the tool into the work. Instead, lower the spinning accessory lightly to the work and allow it to touch the point at. which you want cutting (or sanding or etch-" ing, etc.) to begin. Concentrate'on guiding the tool over the work using very little pros- sure from your

Pernaps you should be using a different cutter, and perhaps an adjustment in speed would solve the problem. But lean ing on the tool seldoms helps. Speed Settings " Speed for light cuts, caution burning on deep grooves. t" Depending on cutting direction relative to grain. CATALOG NUMBER I WOOD WOOD PLJ_STIC BRASS, ETO, STONE CERAMIC tI HIGH SPEED CUTTERS 100. 121.131.141 5. 5 3 t 2 4 114.124,134.144 5 3 2 t 1-2 2 189.190 5 5 2 4 5 118.191.193 5 5 2 3 5 192,194 5 5 2 3 5 118,117,125,196 5 3 2 2 2

It will give youtips on some of the many different do-it-yourself jobs the tool will perform around your home and workshop. WARNING For your own safety read your Owner's Manual assembly • operation • safety instructions. before operating your Dremel Moto-Tool OREMEL _.o.,o_ _ Racine, Wisconsin 53401 1/88 PRINTED IN U.S.A. 5296077 When using electric tools, basic safety precautions should always be followed to reduce the risk of fire, For Your Safety... electric shock, and personal injury, includ

!WARNING It is important to read and understand the section in this manual called “Kickback and Related Warnings”. FIG.4PADDLESWITCH"LOCK-ON" BUTTON"LOCK-OFF"SWITCHRELEASE LEVER DEPTH ADJUSTMENT DEPTH Disconnect plug from power source. Loosen the depth adjustment lever located on the right side of the tool. The foot is spring loaded and will lower automatically (Fig. 5). Tighten lever counter clockwise at the depth FIG. 5 setting desired. Check desired depth (Fig. 5). DEPTHSCALEADJUSTMENTLEVER L