Stimmen - 0, Durchschnittliche Bewertung: 4 ( )

Hersteller: Black & Decker Dateigröße: 1.31 mb Dateiname: Unterrichtssprache:

1. To mount the tool to a vertical surface, place the magnetic drill press on the prepared surface. Push the magnet button on to activate the magnet. 2. Route the safety chain through the lower carrying handle and wrap it tightly around a solid, rigid structure as shown (Fig. 5). 3. Eliminate any slack in the chain. Hook the safety chain together using the snaphook provided. 4. Secure the safety chain with a c-clamp or similar device. This will hold the chain in place and prevent the tool from sliding down the vertical surface. WARNING To reduce the risk of injury, wear safety goggles or glasses with sideshields. Unplug the tool beforechanging accessories or makingadjustments. Control Panel Fig. 6 A B CD, E A - Drill Rotation Speed - Fast/Slow Adjusting the dial changes the drill rotation speed electronically. The higher numbers on the dial produce faster rotation. B - Forward Drill Button C - Reverse Drill Button The drill may be set to two positions: forward and reverse. 1. For forward (clockwise) rotation, push the green forward button. Check the direction of rotation before use. 2. For reverse (counterclockwise) rotation, push the yellow reverse button. Check direction of rotation before use. D - Magnet Button - On/Off The magnet button must be activated before the drill will run. 1. To turn the magnet on, push the “Magnet” button. The red indicator light will turn on. 2. To turn the magnet off, push the “Magnet” button. The red indicator light will turn off. E - Drill and Magnet Interlock The drill will not operate unless the button is pushed and the red indicator is on. If the operator attempts before turning on the magnet, will not function. 9 To start the drill: 1. Push the magnet button to activate the magnet. 2. Make sure the red indicator light is on. If the light is flashing, check for the following: • Low voltage at plug • Loose motor connection • Mag panel buttons are jammed or stuck If flashing light still occurs, take entire unit to an authorized service center. 3. Push a drill button for forward or reverse. If a loss of line voltage occurs while the drill is running, the drill will stop. Gear Shift Lever Fig. 7 Cat. Nos. 4292-1 and 4297-1 operate in either high or low speed. Use low speed for large diameter bits and high speed for small diameter bits (see “Specifi cations” chart). To change speeds, turn the drill off and rotate the lever up or down while the drill is coasting to a stop. NOTE: To avoid damage to the gearbox, do not shift at full speed, when the tool is under load, or when the tool has stopped. The gear shift on the motor is labeled: L - for low speed H - for high speed Typical Operation 1. Insert the bit into the chuck or (see “Keyed Chuck" or "Morse Taper Socket” and “Using Twist Drills" and "Using MILWAUKEE STEEL HAWG™ Cutters”). 2. Place the magnetic prepared surface. 3. Position the unit so that the tip of the drill bit is directly over the center of the hole to be drilled. 4. Push the magnet button. The red i...

Herunterladen

Geben Sie zwei Ziffern: