Stimmen - 5, Durchschnittliche Bewertung: 4.2 ( )

Hersteller: Black & Decker Dateigröße: 1.31 mb Dateiname: Unterrichtssprache:

4. Push the magnet button. The red indicator light will turn on. 5. Attach the safety chain if drilling overhead or on a vertical surface. 6. Check the gear speed setting and change if required. 7. Push the forward or reverse button as required. 8. Drill hole (see “Using Twist Drills" and "Using MILWAUKEE STEEL HAWG™ Cutters”). 9. Push the “Drill Off” button. 10. Remove the chain (if drilling overhead or on a vertical surface). 11. Push the magnet button. The red indicator light will turn off. Using the Adjustable Base (4203 only) Fig. 8 1. Turn the drill motor off. 2. Position the magnetic base so that the drill bit is near the desired hole location and push the magnet button. The red indicator light will turn on. 3. Loosen the adjusting handle located at the back of the housing base. Move the housing to position the drill bit over the center of the hole. Tighten the adjusting handle securely. Keyed Chuck (Select Models) Fig. 9 1. Open the chuck jaws wide insert the bit. Be sure chuck jaws are clean. prevent the bit from 2. When using drill bits, insert the bit into the chuck. Center the bit in the chuck jaws and lift it about 1/32" off of the bottom. Tighten the chuck jaws by hand to align the bit. 3. Place the chuck key in each of the three holes in the chuck, turning it clockwise as shown below. Tighten securely. 4. To remove the bit, insert the chuck key into one of the three holes in the chuck and turn it counterclockwise. - Clockwise (Tighten) - Counterclockwise (Loosen) Morse Taper Socket (Select Models) Fig. 10 These drills are supplied with a No. 3 Morse Taper Socket. To insert a bit or adapter into the socket: 1. Make sure the taper is clean and lightly oiled. Foreign material can cause misalignment. 2. Insert the taper into the socket and rotate the taper until the bit tang slides into the slot at the top of the socket. 3. Press the taper firmly into the socket, or use the feed handle to press the bit against a piece of wood. To remove a bit or adapter from the socket: 1. Unscrew the knurled collar and remove the entire Morse Taper Socket. 2. Strike the bit tang firmly with a soft metal mallet or strike the bit tang firmly on a wood or soft metal surface. 3. Replace the Morse Taper Socket by aligning the notches with tabs on the drill. 4. Replace the knurled collar and 10 APPLICATIONS Fig. 11 DANGER To reduce the risk of injury, always keep hands, rags, clothing, etc. awayfrom moving parts and chips. Do nottry to remove chips while the cutteris rotating. Chips are sharp and canpull objects into moving parts (SeeFig. 11). Drilling When preparing to drill, align the bit with the spot to be drilled. When proper alignment is established, energize the magnet and start the drill motor. A pilot hole is recommended for drilling holes larger than 1/2” in diameter. When drilling, apply only enough force to produce a curled chip. Applying too little force will result in small broken chips and increased drilling time. Applying too much force will...

Herunterladen

Geben Sie zwei Ziffern: