ADJUSTING SHOULDER STRAP HEIGHT A separate safety harness conforming to British Standard BS6684 may be attached to the two “D” rings located at the insertion of the waist harness. POSITION OF CHILD IN SEAT Make sure baby is positioned down as far as possible in seat. Operation 1 2 3 insertion slit buckle shoulder straps SEAT ANGLE Seat back can be reclined to any point between upright and fully reclined position. ALL MODELS To adjust: Pull on buckles to slide straps through buckles and recline s

SWIVELLING FRONT WHEELS Locking the front wheel swivel(s) is recommended for use on uneven ground. There is still a small amount of left and right movement when in the locked position. URBAN Check that brake cog is on the inside next to stroller frame. brake cog Slide wheels onto each end of the axle. 2 brake cog axle TO LOCK: Turn knob so locked symbol is at the top.Then swivel wheel under stroller until it locks into place. TO UNLOCK: Turn knob 1/4 of a turn so ‘Unlocked’ symbol is at the top.

Ask them to read instructions completely. CONVENIENCE STROLLER Operating Instructions Important: Read and follow these Safety Rules and Assembly Instructions before operating stroller. If you have any questions concerning the safe use of this product, contact InSTEP, LLC at 1-800-242-6110, M-F, 8:00 a.m. – 5:00 p.m. CST or visit our web site at or email us at info@instep.net before using. Safety Rules: WARNING: Failure to follow these warnings and assembly instructions could result in serious in

The lower elastic loops fasten onto the lug below the footplate. lug lug strap WARNING: Do not leave Storm Cover on stroller in warm conditions. Check baby’s comfort frequently when using Storm Cover. STORM COVER SUN COVER REFITTING SUNHOOD Place sunhood in position and push one side of wire into plastic joint. Repeat on other side by pulling wire away from frame at the top. Fasten sunhood fabric to stroller frame and seat, near handle bar. Follow removing seat instructions above, in reverse ord

WARNING: This stroller requires regular maintenance by the user. Parts of Stroller Frame Parts of Stroller Frame Note: Diagram is Urban Single model Handle Handlebar Adjuster Sunhood Support Wire Side Tube Sunhood Joint* Fastener Down Tube Brake Cog Brake Cam* Rear Axle Sliding Swivel Lock* Knob* Quick Brake Release Clip* Lever Rear Wheel Heel Rest Sliding Lock* Footplate Front Wheel Accessory Lug Under-Carriage Tube Front Wheel Swivel* (Urban Only) *Points to lubricate periodically Accessories

Ask them to read instructions completely. STROLLER/FRAME CARRIER SB100 Operating Instructions Important: Read and follow these Safety Rules and Assembly Instructions before operating stroller/frame carrier. If you have any questions concerning the safe use of this product, contact InSTEP, LLC at 1-800-242-6110, M-F, 8:00 a.m. - 5:00 p.m. CST or visit our web site at or E-mail us at info@instep.net before using. Safety Rules: WARNING: Failure to follow these warnings and assembly instructions cou

If the product fails within the warranty period: Return it to the Authorized Dealer where purchased from. They will arrange for assessment and appropriate action during normal business hours. If you are unsure where to take stroller contact distributor in your country for instructions. Repairs and replacement parts: If stroller requires repair contact your authorised dealer or distributor, to obtain information and spare parts. If you are in a different country than where you purchased the produ

WARNING: Never place child in stroller with their head forward and feet rearward unless the child is in an approved infant car seat and it is mounted correctly to the stroller using the specially designed car seat adapter bar. See step 9 in the instruction manual. WARNING: Avoid serious injury from falling or sliding out. Always use seat belt. WARNING: Never leave child unattended. WARNING: Never use this stroller with roller skates or in-line skates. WARNING: Never allow stroller to be used as

Losen Sie die Befestigungen welche den Sitz am Rahmen halten. 2. Nur Modell Urban (Jungle): losen Sie den Gurt unter dem Sitz am Punkt A. 3. Nur Modell Terrain: entfernen Sie den Sitz-Stutzdraht vom Kinderwagenrahmen bei Punkt C und D. Drucken Sie den Sitz vorwarts und schieben Sie dann den Stoff von den Sitz- Stutzdrahten. A CD 24 Vorbereitung des Kinderwagens zurBenutzung mit dem Babytragekorb 24 Vorbereitung des Kinderwagens zurBenutzung mit dem Babytragekorb WICHTIGE INFORMATIONEN FUR DOPPEL