Extract the upper flue up to the bracket and fix it with the screws B (Fig.3). - 8 USE • If the apparatus is equipped with the following controls (fig.7A): A = OFF B = SPEED I C = SPEED II D = SPEED III E = LIGHT • If the apparatus is equipped with the following controls (fig.7B): A = LIGHT B = OFF C = SPEED I D = SPEED II E = SPEED III F = AUTOMATIC STOP TIMER - 15 minutes • If your appliance does have the INTENSIVE speed function, press key E for two seconds and it will be activated for 10 min

Re-locate the filters in their seat. USE • If the apparatus is equipped with the following controls (fig.17A): A = OFF B = SPEED I C = SPEED II D = SPEED III E = LIGHT • If the apparatus is equipped with the following controls (fig.17B): A = LIGHT B = OFF/SPEED I C = SPEED II D = SPEED III E = AUTOMATIC STOP TIMER – 15 minutes F = FILTER SATURATION RESET LIGHT When the “filter saturation” light flashes or comes on without flashing, the anti-grease filters must be washed.When this operation has b

- 4 ENGLISH USA ENGLISH USA IMPORTANT SAFETY INSTRUCTIONS FOR RESIDENTIAL USE ONLY READ AND SAVE THESE INSTRUCTIONS PLEASE READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING. IMPORTANT: Save these Instructions for the Local Electrical Inspectors use. INSTALLER: Please leave these Instructions with this unit for the owner. OWNER: Please retain these instructions for future reference. Take care when using cleaning agents or detergents. Suitable for use in household cooking area WARNING - To reduce the ris

B. Zement, Rigips usw.) geeignete Schrauben und Dubel verwenden. Den Bugel (Z) an der Wand anbringen (Abbildung 2)Die beiden Anschlusse senkrecht zur Haube ausrichten. Den Anschluss (F) unter Verwendung der beiden Bohrungen (H) (Abbildung 2) anbringen. Den Anschluss (E) von dem Anschluss (F) abnehmen und seitlich mit den entsprechenden Schrauben am Bugel (Z) anbringen. •MONTAGE DER MILCHGLASSCHEIBE (SONDERZUBEHOR) Die Milchglasscheibe mit den Halterungen (V) wie auf (Abbildung 1) gezeigt ausrich

INSTALLATION INSTRUCTIONS 4. WARNING – TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: 4.1. Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards, including fire-rated construction. 4.2. Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney) of fuel burning equipment to prevent back drafting. Follow the heating equipment manufacturer’s gu