The reason for this order is that with the power feeder unit completely assembled, it will be easier to locate where on the table top you will need to drill your base mounting holes, so you can take advantage of the full range of power feeder swing and adjustments. Through-Bolt Mounting We recommend that you mount your new power feeder to the machine table with through bolts, nuts, and washers (Figure 9). This option will give the most rigidity and clamping strength to prevent the feeder base
#LO9344 PRINTED IN CHINA ...........................................................................................................................................................................................................................................................................................................................................................................................................................................................................................
#TS9402 PRINTED IN CHINA ...........................................................................................................................................................................................................................................................................................................................................................................................................................................................................................
The owner of this welder MUST maintain the original location and readability of the labels on the welder. If any label is removed or becomes unreadable, REPLACE that label before using the welder again. Contact Grizzly at (800) 523-4777 or to order new labels. -16- H8153 DC Stick/TIG Pulse Welder
—Threshold Limit Values (Booklet) -6 H8151 230V Mini Welder H8151 230V Mini Welder -7- SECTION 2: CIRCUIT REQUIREMENTS Circuit Requirements Amperage Draw The Model H8151 welder draws the following amps under maximum load: Draw at 220V ......................................... 24 Amps Circuit Requirements Connect your welder to a dedicated and grounded circuit that is rated for the amperage given below. Never replace a circuit breaker on an existing circuit with one of higher amperage without con
Adjust the trigger knob until there is no air escaping from the cleaning gun. 3. Connect the siphon hose to the cleaning gun and place the other end into an approved container of engine cleaning solution. shown). 4. To adjust the amount of solution being used, rotate the siphon knob; to adjust the amount of air flow; rotate the trigger knob. 5. Hold the gun so the nozzle is 6-10" from the surface and squeeze the trigger knob. 6. When you are done, place the siphon hose into a clean bucket o
Failure to do this may result in serious personal injury. The Model G4176 power feeder is equipped with two sets of change gears that provide four different feed rates of 20, 26, 33, and 43 feet per minute. The Model H3236 Slow Speed Kit provides two additional feed rates of 13 and 62 feet per minute. Use the table below (Figure 1) and these instructions to install the required change gears to get your desired feed rate. Change Gear and Feed Rate Chart Model H3236 Slow Speed Kit Gears: A, 16
WaRNiNG: NO PORtiON OF tHiS MaNuaL May bE REPRODucED iN aNy SHaPE OR FORM WitHOut tHE WRittEN aPPROvaL OF GRizzLy iNDuStRiaL, iNc. #Cr10816 priNtEd iN taiWaN ......................................................................................................................................................................................................................................................................................................................................................