Is the laundry too much? The laundry is not throughly dried (someof the clothes still wet after dryer stops) Is the power cord inserted? Insert the power cord firmly. Is the door closed? Close the door Does the laundry twist? Loose the twisted laundry anddry again. Have any clothes dry easily andhardly been dried together? Dry the undried laundry again. Dry the undried laundry again. Is the dryer placed in a smalland badly-vented space? Place the dryer in a well-vented place. Specification Rated

For clothes resistant to heat, (Check the lable on the article to be dried, to make sure it can be safely tumble dried) , the heater is working. According to clothes materials and quantity, turn the timer knob to relative position. Select 'Strong Dry' for clothes particularly thick and in large quantities. Refer to 'Dry Time Reference Table'. Motor keeps running after dryer time heating finished while heater stops working and cold air into the drum to cool laundry. The whole cooling will be fini

If flexible metal (foil type) duct is installed, it must be of a specific type identified by the appliance manufacturer as suitable for use with clothes dryers. Flexible venting materials are known to collapse, be easily crushed and trap lint. These conditions will ostruct clothes dryer airflow and increase the risk of fire. 4. To reduce the risk of severe injury or death, follow all installation instructions. Tools and materials required • Phillips-Head and flathead screwdrivers • Channel-l

10 Installation dans un placard........................................................... 1 1 Instructions pour maisons mobiles ................................................... 12 Remplacement de l'ampoule du tambour ......................................... 13 Installation électrique ..................................................................... 14 Branchements de cordons à 3 fils ................................................... 15 Branchements de cordons à 4 fils ..........

The dryer exhaust system MUST be exhausted to the outdoors. If the dryer is not exhausted outdoors, some fine lint will be expelled into the laundry area. An accumulation of lint in any area of the home can create a health and fire hazard. 3. Exceeding the length of duct pipe or number of elbows allowed in the "Maximum Length" chart can cause an accumulation of lint in the exhaust system. Plugging the system could create a fire hazard, as well as increase drying times. 4. Do not screen the exh

N'utilisez pas le téléphone dans votre immeuble. 3. Faire sortir tous les occupants de la pièce, de l'immeuble ou de la zone avoisinante. 4. Appelez immédiatement votre fournisseur de gaz du téléphone d'un voisin Suivez les instructions de votre fournisseur de gaz. 5. Si vous ne pouvez joindre le fournisseur de gaz, appelez le service d'incendie. Les installations doivent être effectuées par un installateur, un entrepreneur, un plombier qualifié ou certifié, ou encore par un monteur d'instal

gas service without converting the gas valve. An L.P. Conversion Kit must be installed by a qualified gas technician. 1. Remove the shipping cap from gas pipe at the rear of the dryer. 2. Connect a 1/2 inch (1.27 cm) I.D. semi-rigid or approved pipe from gas supply line to the 3/8 inch (0.96cm) pipe located on the back of the dryer. Use a 1/2 inch to 3/8 inch (1.27 cm to 0.96cm) reducer for a connection. Apply an approved thread sealer that is resistant to the corrosive action of liquified gas

Les articles contaminés par l'huile de cuisson peuvent contribuer à une réaction chimique qui pourrait faire s'enflammer une charge. 3 Français 16. Tout matériel ayant été exposé à quelque liquide ou solide inflammable que ce soit ne devrait pas être placé dans la sécheuse à moins que toute trace de liquide ou de vapeur inflammable ait été éliminée. 17. Cette sécheuse doit être installée correctement, et ce, conformément aux instructions d'installation, avant d'être utilisée. Consultez les in

9.To prevent fire, do not use heat to dry items containing plastic, foam,rubber or similarly textured rubber-like materials, or items containing feathers or down. 10.Do not place items exposed to cooking oils in your dryer. Items contaminated with cooking oils may contribute to a chemical reaction that could cause a load to catch fire. 11.Clean lint screen before or after each load. 12.This dryer must be properly installed in accordance with the installation instructions before it is used . 13.T

Open the screen and clean off the dust on the screen with a wet towel. After cleaning, put the screen back in place. 3. Emptying the water collection box During operation , steam condenses into water and is collected in the box.The box must be emptied after the program is complete. -Hold the handle and pull the box outwards to remove it. keep it level to prevent the water from overflowing; -Pour away water. Note: the water can not be used for drink or for food processing; -Put the box back in pl