Stimmen - 4, Durchschnittliche Bewertung: 4 ( )

Hersteller: Amana Dateigröße: 3.01 mb Dateiname: hde5000aw_manual.pdf Unterrichtssprache:

If flexible metal (foil type) duct is installed, it must be of a specific type identified by the appliance manufacturer as suitable for use with clothes dryers. Flexible venting materials are known to collapse, be easily crushed and trap lint. These conditions will ostruct clothes dryer airflow and increase the risk of fire. 4. To reduce the risk of severe injury or death, follow all installation instructions. Tools and materials required • Phillips-Head and flathead screwdrivers • Channel-lock adjustable pilers • 1/2-inch open-end wrench • Carpenter's level • Measuring tape (12ft. min.) • Duct tape • Pipe thread sealer (Gas) • Rigid or flexible metal 4 inch (102cm) duct • Vent hood ^ Safety Warning: 1. Before starting installation, make sure that the gas shut off valve is in the off position. 2. All old gas connectors and gas piping should be discarded. ELECTRICAL REQUIREMENTS (Electric Dryers) Model Numbers: (chde/hde5000AW and chde/hde5300AW) Circuit Individual 30 Amp branch circuit fused with 30 Amp time-delay fuses or circuit breakers. 5 English Power Supply 3 or 4 wire, 120/240 Volt, 1 Phase, 60Hz, AC Power Supply Cord Kit (Not supplied when sold in US. Must be purchased to meet local electrical codes.) The dryer MUST employ a 3-conductor power supply cord NEMA 10-30 Type SRDT rated at 240 Volt AC minimum, 30 Amp, with 3 open end spade lug connectors with upturned ends or closed loop connectors and marked for use with clothes dryers. (When sold in Canada - 4-wire power supply cord provided and attached on dryer) Dryers being installed in a manufactured (mobile) home MUST employ a 4-wire power supply cord NEMA 14-30 type SRDT or ST (as required) rated to 240 Volt AC minimum, 30 Amp, with 4 open-end spade lug connectors with upturned ends or closed loop connectors and marked for use with clothes dryers. See Electrical Connections for more information on a 4-wire system. Outlet Receptacle NEMA 10-30R receptacle should be located so the power supply cord is accessible when the dryer is in the installed position. (Canada - NEMA 14-30R receptacle) ELECTRICAL REQUIREMENTS (Gas Dryers) Model Numbers: (HDG5000AW and HDG5300AW) Circuit Individual 15 Amp branch circuit fused with 15-Amp maximum time delay fuse or circuit breakers. Power Supply 3 wire, 120 Volt, 1 Phase, 60Hz, AC Power Supply Cord The dryer is equipped with a 120 Volt 3-wire power supply cord. NOTE: This dryer is equipped with a three-prong grounding plug for your protection against shock hazard and should be plugged into a properly grounded three-prong receptacle. Do not under any circumstance cut or remove grounding prong from plug. Unpacking Your Dryer 1. Remove all packaging material. This includes the foam base and all adhesive tape holding the dryer accessories inside and outside. 2. I nspect and remove any remains of packaging, tape or printed materials before using the dryer. 6 English EXHAUST SYSTEM REQUIREMENTS WARNING The followi...

Herunterladen

Geben Sie zwei Ziffern: