Login:
heruntergeladen wurde: 4   Dateigröße: 7 mb   Hersteller: Ariens  
Kategorie: Schneefräsen
@name

(If engine does not start, refer to TROUBLESHOOTING on page 30.) 7. Adjust choke as needed. 8. Set throttle to Part Throttle or Slow position for travel or adaptation to outside temperature. Once achieved, set throttle to Fast position for normal operation. Shut Off 1. Release Traction Drive Clutch Lever and allow unit to come to a complete stop. 2. Run Impeller a few minutes after use to prevent freeze-up of Impeller. 3. Release Attachment Clutch Lever and wait for all moving parts to come to a

heruntergeladen wurde: 1   Dateigröße: 7 mb   Hersteller: Ariens  
Kategorie: Schneefräsen
@name

3. Check Dual Handle Interlock Without the engine running, press down (engage) both clutch levers. Release attachment clutch lever. Attachment clutch should remain engaged until traction clutch lever is released, then both clutches must disengage. If clutches do not engage or disengage properly, adjust or repair before operation (see SERVICE AND ADJUSTMENTS on page 22). 4. Check Remote Differential (926004, 005, 006, 300, 301, 500, 501) Test the remote differential lock before starting. Squeeze

heruntergeladen wurde: 1   Dateigröße: 7 mb   Hersteller: Ariens  
Kategorie: Schneefräsen
@name

IMPORTANT: Gradually open choke after engine starts. 1 OS1332 GB - 14 GB - 15 Throttle The throttle controls the engine speed. To increase or decrease the engine speed, adjust to: 1. Fast (normal or warm starts) 2. Part-Throttle 3. Slow (cold weather starts) 4. Stop (engine is off) (Not on 12V models) Electric Starter (120V electric start models) The electric starter will start a properly choked and cranked engine when the key is turned (12V) or starter button (120V or 240V) is pushed. Refer to

heruntergeladen wurde: 2   Dateigröße: 7 mb   Hersteller: Ariens  
Kategorie: Schneefräsen
@name

OS7156 4 4 Figure 8 OS7270 Figure 9 1.Cable Anchor 2.Cable End 3.Deflector Cable 4.Cable Fitting 5.Cable Bracket 1 2 3 5 4 3 OS7070 Connect Battery (926500, 501) 1. Remove wing nuts from battery cover. 2. Install wire lead to battery terminal. 3. Install battery cover and tighten wing nuts. Check Function of Dual Handle Interlock Without the engine running, press down (engage) both clutch levers. Release attachment clutch lever. Attachment clutch should remain engaged until traction clutch lever

heruntergeladen wurde: 2   Dateigröße: 7 mb   Hersteller: Ariens  
Kategorie: Schneefräsen
@name

Follow with Milk of Magnesia, beaten egg or vegetable oil. Get medical attention immediately! • In case of internal contact, DO NOT induce vomiting! Before tipping unit up onto housing, remove fuel so no spills will occur and remove battery. Ensure unit is secure and will not tip over during maintenance. ALWAYS keep protective structures, guards, and panels in good repair, in place and securely fastened. NEVER modify or remove safety devices. DO NOT change engine governor settings or over-speed

heruntergeladen wurde: 9   Dateigröße: 7 mb   Hersteller: Ariens  
Kategorie: Schneefräsen
@name

DO NOT throw snow any higher than necessary. Deflected materials can cause injury and property damage. Always stand clear of the discharge area when operating this unit. Fumes from engine exhaust can cause injury or death. DO NOT run engine in an enclosed area. Always provide good ventilation. ALWAYS disengage attachment, stop unit and engine, remove key and allow moving parts to stop before leaving operator’s position. ROTATING IMPELLER CAN CAUSE SERIOUS INJURY. NEVER ATTEMPT TO UNCLOG OR CLEAN

heruntergeladen wurde: 0   Dateigröße: 7 mb   Hersteller: Ariens  
Kategorie: Schneefräsen
@name

PRACTICES AND LAWS Practice usual and customary safe working precautions, for the benefit of yourself and others. Understand and follow all safety messages. Be alert to unsafe conditions and the possibility of minor, moderate, or serious injury or death. Learn applicable rules and laws in your area. Always follow the practices set forth in this manual. REQUIRED OPERATOR TRAINING Original purchaser of this unit was instructed by the seller on safe and proper operation. If unit is to be used by so

heruntergeladen wurde: 6   Dateigröße: 7 mb   Hersteller: Ariens  
Kategorie: Schneefräsen
@name

Ear Sound Pressure (Lpa) in dBA – Pression acoustique Pression sonore a aux oreilles de l’operateur (Lpa) en dBA – Gerauschstarke am Ohr des Bedieners (Lpa) in dBA – Potenza sonora percepita dall’operatore (Lpa) in. dBA – Presion de sonido en el oido (Lpa) in dBA – Lydtrykk i forerens ore (Lpa) in. dBA – vid forarens position (Lwa) i dBA – Kuljettajan korvaan kohdistuva aanipaine (Lpa)/dBA – Robocze cioenienie akustyczne na uchu (Lpa) w decybelachA – Provozni hladina akustickeho tlaku (Lpa) v dB

heruntergeladen wurde: 1   Dateigröße: 7 mb   Hersteller: Ariens  
Kategorie: Schneefräsen
@name

DURA-CLEAN™ Auger Limited Lifetime Warranty Ariens Company (Ariens) warrants to the original purchaser that the rubber components of the DURA-CLEAN™ Auger manufactured by Ariens Company will be free from defects in material and workmanship and will not wear out for the life of the Sno-Thro, except as noted below. Ariens Company will provide for the replacement of any of the rubber components of the DURA-CLEAN™ Auger found upon examination by the Ariens Company to be defective or worn out. Replac

heruntergeladen wurde: 3   Dateigröße: 7 mb   Hersteller: Ariens  
Kategorie: Schneefräsen
@name

(cm) 16 (40.6) Speed - RPM- Max (min-1) 121 Auger Brake Yes Attachment Clutch Yes Drive Disc-O-Matic Speeds 6 Forward and 2 Reverse Lock Out Differential Pin-Lock Remote Wheel Lock Remote Wheel Lock Remote Differential Remote Differential Remote Wheel Lock Pneumatic Tires - in. (cm) 15/5 x 6 (38.1/12.7 x 15.2) 15/5 x 6 (38.1/12.7 x 15.2) 16/6.5 x 8 (40.6/16.5 x 20.3) 16/6.5 x 8 (40.6/16.5 x 20.3) 16/6.5 x 8 (40.6/16.5 x 20.3) 16/6.5 x 8 (40.6/16.5 x 20.3) Size and Weight Length - in. (cm) 61.5 (





Kategorien