Login:
heruntergeladen wurde: 0   Dateigröße: 3 mb   Hersteller: Gravely  
Kategorie: Schneefräsen
@name

See figure 6.0-2. 5. Lower the snowblower to the ground. 6. Put the RANGE selector in the LO position. I - Discharge Chute Crank Figure 6.0-2. 7. Engage the PTO. 8. Move the throttle lever to the FAST position. 9. Put the GEAR selector in the 2 position. NOTE: When going through the snow for the first time, a full width passage must be cut. The forward speed must be slow enough to permit the snow to go through the discharge chute without being stopped. 10. Put the Direction Control Lever in the

heruntergeladen wurde: 4   Dateigröße: 3 mb   Hersteller: Gravely  
Kategorie: Schneefräsen
@name

Snowblower Weldment, Body; 44 In. Snowblower Weldment, Crank Support Bolt, Hex; 1/4-20 x 7/8 3.0 CONNECTING THE SNOWBLOWER TO THE TWO WHEEL TRACTOR 1. Install the Quick Hitch Pin Kit as shown 8. Put the ring pin through the hole in the end of the in figure 3.0-1. quick hitch pin as shown in figure 3.0-2. 1 -Quick Hitch Pin 2 - Bolt 3 -Attachment Adapter 4 --- Bushing Figure 3.0-1 2. Put the bushing on the 1/2" x 2-3/4" Bolt and fasten to the upper, left quick hitch stud as shown in figure 3.0-1.

heruntergeladen wurde: 0   Dateigröße: 3 mb   Hersteller: Gravely  
Kategorie: Schneefräsen
@name

Shaft 15 20728 1 Joint, Universal; Rect. Tube 16 Refer to Reel Drive Assembly NOTE: Circle A Pertains to 38" & 44" Riding Snowblowers Only SNOWBLOWERS, 28", 34", 38" & 44" CRANK ASSEMBLY ITEM NO. PART NO. QTY. DESCRIPTION 1 20984 1 Bracket, Support 2 20999 1 Spring, Compression 3 19340 1 Race, Bearing Thrust; 1.002 x 1.552 x .030 4 20989 1 Shaft 5 456542 2 Pin, Spring; 3/16 x 1-1/2 6 21144 1 Eye, Single 7 20997 1 Assembly, Cable 8 20998 1 Support 9 9630 2 Clamp, Hose SAE; Type F 10 9612 1 Connec

heruntergeladen wurde: 0   Dateigröße: 3 mb   Hersteller: Gravely  
Kategorie: Schneefräsen
@name

The 38 Inch and 44 Inch Snowblowers are used with Gravely four wheel tractors. To fasten the Snowblower to a Gravely two wheel tractor a Quick Hitch Pin Kit, part No. 23220, is needed. To fasten the Snowblower to a Gravely four wheel tractor a Front Drive Kit, part No. 21124, is needed. All reference to left side, right side, front and rear are from the operator's position. To continue its program of quality and design improvement, Form No: 24729 (6-78) Printed in U.S.A. the manufacturer reserve





Kategorien