Stimmen - 4, Durchschnittliche Bewertung: 3.8 ( )

Hersteller: Zenoah Dateigröße: 712.79 kb Dateiname: Unterrichtssprache:

6. After the engine has started, open the choke guradually and allow the engine to warm up. Pull the throttle lever to unlock it. ¦ STOPPING THE ENGINE 1. Release the throttle lever. 2. Move the engine switch to the "O" position. BC2610WE BC3500WE BC4500WE BC2310LE BC2610LE 2 BC530WE BC3500LE1 ¦ ADJUSTMENTS • Throttle cable: The normal play is 1 or 2 mm when measured at the carburetor side end. Readjust with the cable adjuster(1) as required. • Engine idling speed: It is normal that the engine keeps running without the blade rotation, when the throttle lever is released. When the engine speed is too high or too slow, readjust the idle set screw (2). BC2310LE/BC2610LE/WE BC3500LE/WE/BC4500WE BC530WE ¦ CUTTING WORK • By using the shoulder strap, hang the unit on your right side. Adjust the strap length so that the cutting head may become parallel to the ground. • Choose a suitable recommended cutting attachment according to the object to be cut. Never use other cutting attachment not approved by ZENOAH. ¦ LINE HEAD USAGE WARNING 1. Always wear eye protection such as safety goggles. Never lean over the rotating cutting head. Rocks or other debris could be thrown into eyes and face and cause serious personal injury. 2. Keep the debris guard attached in place at all times when the unit is operated. TRIMMING GRASS AND WEEDS • Always remember that the TIP of the line does cutting. You will achieve better results by not crowding the line into the cutting area. Allow the unit to trim at its own pace. 1. Hold the unit so the head is off the ground and is tilted about 20 degrees toward the sweep direction. 2. Use full throttle when cutting. 3. You can avoid thrown debris by sweeping from your left to the right. 4. Use a slow, deliberate action to cut heavy growth. The rate of cutting motion will depend on the material being cut. Heavy growth will require slower action than will light growth. 5. Never swing the unit so hard as you are in danger of losing your balance or control of the unit. 6. Try to control the cutting motion with the hip rather than placing the full workload on the arm and hands. 7. Take precautions to avoid wire, grass and dead, dry, long-stem weeds from wrapping around the head shaft. Such materials can stall the head and cause the clutch to slip, resulting in damage to the clutch system if repeated frequently. ADJUSTING THE LINE LENGTH • Your brushcutters is equipped with a semi- auto type nylon line head that allows the operator to advance the line without stopping the engine. When the line becomes short, lightly tap the head on the ground while running the engine at full throttle. • Each time the head is bumped, the line advance about 1 inch(25.4 mm). For better effect, tap the head on bear ground or hard soil. Avoid bumping in thick, tall grass as the engine may stall by overload. 6 Maintenance Before cleaning, inspecting, or repairing the unit, make sure that the engine has stopped and is cool. ¦ REFILLING TRIMMING LINE 1. For repla...

Herunterladen

Geben Sie zwei Ziffern: