Stimmen - 2, Durchschnittliche Bewertung: 4.5 ( )

Hersteller: Zenoah Dateigröße: 712.79 kb Dateiname: Unterrichtssprache:

Moreover, normal wear and change in product with no functional influence are not covered by the warranty. Also, be careful that, if the usage in the instruction manual is not observed as to fhe mixed gasoline, etc. described therein, if may not be covered by the warranty. 5 Use Use ¦ STARTING THE ENGINE Take care that the cutting head will start rotating upon the engine starts. A: EXCEPT BC530WE 1. Push the primer pump(1) several times until overflown fuel flows out in the clear tube. 2. Move the choke lever(2) to the closed position. B: BC530WE 1-1.Open the fuel shutoff valve. (1) 1-2.While pushing the tickler lever(3), push the primer pump(2) several times until the flow of fuel into the overflow pipe. 2. Move the choke lever(4) to the closed position. 3. A: BC2310LE/BC2610LE/WE BC3500WE/BC4500WE/BC530WE Set the engine switch(a) to the " I " position. Set the throttle lever to the start position (12- 3). BC2310LE BC530WE BC2610LE BC2610WE BC3500WE BC4500WE B: BC3500LE While pulling the throttle lever (1,2), set the engine switch(a) to the “I (START)” position and release the throttle. Then the throttle lever is in to the “start position”. a12BC3500LE 4. Place the unit on a flat, firm place. Keep the cutting head clear of everything around it. 5. While holding the unit firmly, pull out the starter rope quickly. 6. After the engine has started, open the choke guradually and allow the engine to warm up. Pull the throttle lever to unlock it. ¦ STOPPING THE ENGINE 1. Release the throttle lever. 2. Move the engine switch to the "O" position. BC2610WE BC3500WE BC4500WE BC2310LE BC2610LE 2 BC530WE BC3500LE1 ¦ ADJUSTMENTS • Throttle cable: The normal play is 1 or 2 mm when measured at the carburetor side end. Readjust with the cable adjuster(1) as required. • Engine idling speed: It is normal that the engine keeps running without the blade rotation, when the throttle lever is released. When the engine speed is too high or too slow, readjust the idle set screw (2). BC2310LE/BC2610LE/WE BC3500LE/WE/BC4500WE BC530WE ¦ CUTTING WORK • By using the shoulder strap, hang the unit on your right side. Adjust the strap length so that the cutting head may become parallel to the ground. • Choose a suitable recommended cutting attachment according to the object to be cut. Never use other cutting attachment not approved by ZENOAH. ¦ LINE HEAD USAGE WARNING 1. Always wear eye protection such as safety goggles. Never lean over the rotating cutting head. Rocks or other debris could be thrown into eyes and face and cause serious personal injury. 2. Keep the debris guard attached in place at all times when the unit is operated. TRIMMING GRASS AND WEEDS • Always remember that the TIP of the line does cutting. You will achieve better results by not crowding the line into the cutting area. Allow the unit to trim at its own pace. 1. Hold the unit so the head is off the ground and is tilted about 20 degrees toward the sweep direction. 2. Use full throttle when cutting. 3. You c...

Herunterladen

Geben Sie zwei Ziffern: