Stimmen - 2, Durchschnittliche Bewertung: 4.5
(
)
)
|
Anleitung Zusammenfassung
PATENT NOS. Thank you for selecting American-Standard...the benchmark of fine quality for over 100 years. To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin. WARNING: SUPPLY INLET MUST BE FILTERED WITH A 60 MESH SCREEN. USE AMERICAN STANDARD MIXING VALVE WITH STRAINER OR COMMERCIAL 60 MESH STRAINER. 012692D BODY AERATOR KEY ESCUTCHEON KIT (OPTIONAL) WASHER, BRASS LOCK-RING AND SCREWS RISER TUBE (NOT INCLUDED) 1340 SERIES SUPPLY NUT SET SCREWS — HANDLE RETAINING RING - LEVER -VALVE CARTRIDGE HANDLE RETAINER MIXING STRAINER VALVE ASSEMBLY — FILTER SCREEN DUCK — BILL CHECKS 1340M SERIES ASSEMBLING ESCUTCHEON KIT (OPTIONAL) CAUTION Turn off hot and cold water supplies before beginning. Peel off paper backing from PADS and stick both PADS to underside of ESCUTCHEON about 1/4" from ends. Peel off paper backing from WASHER and stick WASHER into circular groove of SUPPORT PLATE. Place SUPPORT PLATE in center WASHER of ESCUTCHEON with WASHER visible Apply a bead of PUTTY around the inside of ESCUTCHEON edge. Turn ESCUTCHEON over and center it with SUPPORT PLATE over center hole of sink deck. PUTTY SUPPORT PLATE ESCUTCHEON ASSEMBLING MOUNTING KIT LOC Thread (3) SCREWS into LOCK RING. SCREWS should extend half-way thru RING. MOUNTING FITTING Install faucet through the ESCUTCHEON being sure the rubber GASKET is between the FAUCET and the ESCUTCHEON. Install brass WASHER and turn LOCK-RING onto SHANK. Tighten (3) SCREWS in the LOCK-RING to secure fitting. FOR 1340 SERIES ONLY Warning; 60 MESH STRAINER required for supply water. Install RISER TUBE (not included) and tighten SUPPLY NUT. Connect RISER TUBE to COLD or TEMPERED water supply. FOR 1340M SERIES Connect FLEXIBLE FAUCET SUPPLIES (1/2" faucet cone on one end, 3/8" compression on the other) to the MIXING VALVE INLETS and the hot/cold wall stops. The FLEXIBLE FAUCET SUPPLIES are NOT included. Turn on WALL STOPS and check for leaks. H With WALL STOPS open and water flowing, adjust MIXING VALVE to temper water. MIXING VALVE MIXING VALVE INLETS OLD vojy 2 SPRING 3 1 PAD Retaining Ring Lift off retaining ring then slide out lever horizontally. Cycle time is factory set but can be changed as shown. TO SERVICE TO remove HANDLE use a 3/32" ALLEN WRENCH to loosen three set screws in the HANDLE as shown in Figure A. Remove VALVE CARTRIDGE for cleaning or replacement, see in Figure B. VALVE TIGHTEN SET SCREWS Reassemble in reverse order, Figures C & D. HANDLE CARTRIDGE REMOVE ft 3/32" ALLEN WRENCH Figure A REPLACE TIGHTEN VALVE CARTRIDGE Figure D Figure B Figure C SPRAY INSTALLATION/REMOVAL 0 Use included key to install SPRAY into spout end. HOTLINE FOR HELP For toll-free information and answers to your questions, call: 1 (800) 442-1902 Weekdays 8:00 a.m. to 7:00 p.m. Eastern Time IN CANADA 1-800-387-0369 (TORONTO 1-905-306-1093) Product names listed herein are tradem...
Dieses Handbuch ist für folgende Modelle:Andere Home Zubehör - 1340M Series (158.84 kb)