This information has been provided in the interest of your safety.You MUST read it carefully before installing or using the appliance. Installation . This appliance is heavy. Care should be taken when moving it. . Check your dishwasher for any transport damage. Never connect a damaged machine. If your dishwasher is damaged, you should contact the John Lewis Branch from which you purchased. . For safety reasons it is dangerous to alter the specifications or attempt to modify this product in any w

The following symbols are used in the text: 1 Safety instructions Warning! Information that affects your personal safety. Important! Information that prevents damage to the appliance. 3 Useful tips and hints 2 Environmental information 3 Your dishwasher is fitted with the new “PULSE WASH” dishwashing system. With this dishwashing system the motor speed and spray pressure are varied during the dishwashing cycle to achieve better cleaning of the dishes. It is for this reason that the noise level v

Attention! Hot steam may escape when the door is opened. Open the door carefully. Interrupt a washing programme in progress Open the dishwasher door; the programme will stop. Close the door; the programme will start from the point at which it was interrupted. Cancel a washing programme in progress Open the dishwasher door. Press simultaneously function buttons 2 and 3 for about 2 seconds.After about 2 seconds all the programme indicator lights will illuminate indicating that the running programm

These warnings have been provided in the interest of safety. You MUST read them carefully before installing or using the appliance. If you are unsure of the meanings of these warnings contact the John Lewis branch from which you purchased the appliance. Installation • This appliance is heavy. Care should be taken when moving it. • Check your dishwasher for any transport damage. Never connect a damaged machine. If your dishwasher is damaged, you should contact the John Lewis branch from which you

2. To a stand pipe provided with vent-hole, minimum internal diameter 4 cm. The waste connection must be at a height of between 30 cm (minimum) and 100 cm (maximum) from the bottom of the dishwasher. The drain hose can face either to the right or left of the dishwasher Ensure the hose is not bent or squashed as this could prevent or slow down the discharge of water. The sink plug must not be in place when the machine is draining as this could cause the water to syphon back into the machine. If y

If the appliance is partially loaded and the dishes lightly soiled, the "prewash", "main wash", and "rinse" phases of the programme are shorter and the water consumption level is lower. If the appliance is fully loaded and the dishes heavily soiled, the "prewash", "main wash", and "rinse" phases of the programme are longer and the water consumption level is higher. During the "Automatic" programme the temperature of the main wash water is also automatically adjusted between 50°C and 65°C dependi

Fill the salt container and the rinse aid dispenser. 2. Adjust manually and electronically the water softener to the highest level. 3. Start a washing programme without dishes. 4. When the washing programme is completed, adjust the water softener to the water hardness in your area. 5. Adjust the rinse aid dosage. 17 Select and start a washing programme Starting the washing programme 1. Switch on the appliance. Make sure that the appliance is in setting mode. 2. Select a washing programme. Refer

The dose is factory set in position 4. Increase the dose if there are drops of water or lime spots on the dishes after washing. Reduce it if there are sticky whitish streaks on the dishes or a bluish film on glassware or knife blades. 14 Daily use • Check if it's necessary to refill with dishwasher salt or rinse aid. • Open the door and slide out the baskets to load the dishes. • Load cutlery and dishes into the dishwasher. • Fill with dishwasher detergent. • Select a wash programme suitable for

Indicator lights Salt 1) Comes on when the special salt has run out. Rinse aid 1) Comes on when the rinse aid has run out. Indicator lights Multi tab Indicates the activation/ deactivation of the Multi tab function (See 'Multi tab function'). 1) The salt and rinse aid indicator lights are never on while a washing programme is running even if filling with salt and/or rinse aid is necessary. 7 The digital display The digital display indicates: • The level of hardness to which the water softener is

These warnings have been provided in the interest of safety. You MUST read them carefully before installing or using the appliance. If you are unsure of the meanings of these warnings contact the John Lewis branch from which you purchased the appliance. In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensu