|
Anleitung Zusammenfassung
G DC IN 3V jack (9) (12) (51) H i (headphones/earphones) jack (10) (38) I REC (record) switch (13) (20) J (search/AMS) button (13) (17) (43) CHARGE/x (stop) button (9) (13) (16) (22) K Display window (29) L MENU/ENTER button (22) (32) (40) M Battery compartment (9) N LINE IN (OPTICAL) jack (12) (20) 6-GB P HOLD switch (10) (37) O MIC (PLUG IN POWER) jack (25) There is a tactile dot beside the MIC (PLUG IN POWER) jack. The display window A BCD EFGHIJK A Character information display (31) (33) Displays the disc and track names, error messages, track numbers, etc. B Play mode indication (33) Shows the play mode of the MD. C Time display D Battery indication (50) Shows approximate battery condition. E Mega bass indication (34) F Level meter (29) Shows the volume of the MD being played or recorded. G Recording mode (LP2/LP4/ MONO) indication H SYNC (synchro-recording) indication I REC indication (13) Lights up while recording. When flashing, the recorder is in record standby mode. J REC REMAIN/ REMAIN (remaining time/ tracks) indication (31) (35) Lights up along with the remaining time of the track, the remaining time of the MD, or the remaining number of tracks. K Disc indication Shows that the disc is rotating for recording, playing or editing an MD. 7-GB The remote control A B C D E F G H I A ./>/N (search/ AMS/play) • >/. button (16) (30) (32) (41) (47) B x (stop) • ENTER button (16) (30) (32) (41) C X (pause) • CAPS button (17) (43) (47) D EDIT button (32) (40) (47) E VOL +/–buttons (16) (47) F Headphones/earphones Can be replaced with optional headphones/ earphones. G HOLD switch (37) Slide to lock the controls of the remote control. H T MARK button (41) (47) I DELETE button (47) 8-GB Getting started! Charge the rechargeable battery before using. Even if the rechargeable battery is not charged, you can use the recorder as long as the AC power adaptor is connected. 1Insert the rechargeable battery. (Insert the rechargeable battery minus end first) 2Charging the rechargeable battery. CHARGE (x) to a wall outlet to DC IN 3V 1 Connect the supplied AC power adaptor. 2 Press CHARGE (x). “Charging” flashes, e appears in the display, and charging starts. When charging is completed, the battery indication disappears. Full charging of a completely discharged rechargeable battery takes about 3 hours. To cancel charging, press CHARGE (x). 3 Disconnect the supplied AC power adaptor. 9-GB 3Make connections and 3Make connections and unlock the control. HOLD to i 1 Connect the supplied 2 Slide HOLD in the opposite headphones/earphones with direction of the arrow (.) the remote control to i. to unlock the controls. 4Insert an MD. (Use a recordable MD for recording.) 1 Press OPEN to open the lid. 2 Insert an MD with the label side facing front, and press the lid down to close. 10-GB Using on a dry battery Insert one LR6 (SG) alkaline dry battery (not supplied) instead of the rechargeable battery. Notes • If you press CHARGE (x) immediately after charging has completed, charging will begin again. If this happens, press CHARGE (x) again to stop the changing operation since the battery is already fully charged. • Charging stops when you try to operate the recorder during charging. • Be sure to use the supplied AC power adaptor. • Charging time may vary depending on the battery condition. • When a rechargeable battery is charged for the first time or charged after a long period of disuse, battery life may be shorter than usual. Repeat discharging and recharging a few times. The battery life should return to normal. • When the battery life of a fully charged rechargeable battery becomes about half the normal life, replace it. • When carrying the rechargeable battery, keep it in the supplied battery carrying case. It is dangerous to carry the battery out of the case in your pocket or a bag together with metallic objects such as key rings, as this may cause a short circuit. • Remove the rechargeable battery from the recorder when it is not to be used for a long time. 11-GB Recording an MD right away! Connect to a digital source using an optical cable (supplied) to make digital recordings. Digital recording is possible even from digital equipment with different sampling rates, such as a DAT deck or a BS tuner, using the built-in sampling rate converter. To record from an analog source, see “Recording with analog input (line cable required)” (page 20). To record from an MD, see “Note on digital recording” (page 54). Using the AC power adaptor (supplied) is recommended for recording. 1Make connections. (Insert the cables firmly and completely into the appropriate jacks.) to a wall outlet AC power adaptor (supplied) CD player, MD player, DVD video player, etc. Portable CD player, etc. Optical cable (supplied)* Optical plug Optical mini- plug to DIGITAL OUT (OPTICAL) to DC IN 3V to LINE IN (OPTICAL) . The supplied cable consists of one or the o...
Dieses Handbuch ist für folgende Modelle:Player - MZ-R701DPC (1.98 mb)
Player - MZ-R701PC (1.98 mb)