WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC. Printed in Taiwan CONTENTS INTRODUCTION ............................................................................................ 2¦¦¦¦ General........................................................................................................... 2 Warranty ...................................................................................................

This clearance must be uniform along the table surface. It is also very important that the fence does not contact the table surface when sliding from side to side. The support pads, two on the T shaped rail and one on the end of the fence, support the fence above the front and rear rails. As long as those rails are flush with the table surface, the table clearance should be okay. Over time these pads will wear and may eventually need replacement. Replacement pads are available from your dealer.

1 Drill and Tap ................................. 1 Blade Guard Clamp Bag • V-Clamp .................................. 1 • L-Bracket ................................. 1 • Locking Plate ............................ 1 • Hex Bolt 1.4-20 X 11.2" ................. 2 • Flat Washer 1.4" ......................... 4 • Hex Nut 1.4-20 ........................... 2 • Hex Bolt 5.16-18 X 3.4" ................. 1 • Flat Washer 5.16" ....................... 2 • Hex Nut 5.16-18 .......................... 1 Rail

REVISED JANUARY, 2008 (BL) WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC. Printed in Taiwan Contents INTRODUCTION 2 About-Your-New-Aluma-Classic™-Fence 2 Woodstock-Service-and-Support 2 Unpacking 3 Get-To-Know-Your-Fence 3 Location-of-Controls 3 ASSEMBLY 4 Inventory 4 W1716-Installation 5 W1720-Installation 6 Installing-Metal-Extension-Wings 8 ADJUSTMENTS 9 Fence-to-Blade 9 Scale-Installation-And-Adjustment

Note—The tables slide into place easily if you lift up while you slide them into place. 4. Place a straightedge across the top of the wings, and tighten the nuts behind the edge of the extension wings to secure the wings in place. Figure 10. Extension wing box inventory. Figure 11. T-bolt and rail T-slot. Figure 12. Sliding in the wings. -8 ADJUSTMENTS The SHOP FOX® W1716/W1720 Aluma-Classic™ Fence requires little adjustment since most of the features are built in at the factory. The primary adj