Stimmen - 3, Durchschnittliche Bewertung: 4 ( )

Hersteller: Aquacal Dateigröße: 271.13 kb Dateiname: Unterrichtssprache:

If error persists, proceed to next step. Filtration Dirty Step 2: Confirm filtration system is clean. Backwash if needed. If error persists, proceed to next step. Possible Water Pressure Switch Step 3: Request Service “CEr” Error Communication Fault N/A Request Service “CSE” Error Control System Error N/A Request Service “dPC” Error Defrost Sensor Shorted N/A Request Service “dPO” Error Defrost Sensor Open N/A Request Service “FS” Error Unit in defrost mode. Normal defrost mode Step 1: If error persists after air temperature is over 50° F, request service. “HP” Error High Pressure. Insufficient Water Flow Step 1: Confirm water pump is on and water valves are in the correct position to allow water to flow through Heat Pump. If error persists, proceed to next step. Filtration Dirty Step 2: Confirm filtration system is clean. Backwash if needed. If error persists, proceed to next step. Possible Refrigerant Issue Step 3: Request Service “HP5” Error Equipment has registered high pressure five times and locked. Insufficient Water Flow and/or Filtration Dirty Step 1: Follow steps outlined in “HP” error, then reset circuit breaker to clear error. If error persists, request service. “LP” Error Refrigerant Issue N/A Request Service “LP5” Error Refrigerant Issue N/A Request Service “OTA” Over Temperature Alarm Temperature over 110° F (Unit Locked) Other heating equipment Check if alternate heater (such as a solar heater) is heating water leading to heat pump. If “yes”, turn off alternate heater and check if error clears. If error persists, request service. “PC” Error Water Temperature Sensor Shorted N/A Request Service “PO” Error Water Temperature Sensor Open N/A Request Service Table 8 ...

Herunterladen

Geben Sie zwei Ziffern: