Stimmen - 4, Durchschnittliche Bewertung: 4 ( )

Hersteller: Aquacal Dateigröße: 271.13 kb Dateiname: Unterrichtssprache:

“Desired Temp” Setting Desired Water Temperature “Water Temp” Actual Water Temperature “Heating” Actively Heating Water Table 3 BUTTONS BUTTONS EXPLANATION SUPPLEMENTAL INFORMATION “Pool / Spa” Select between Pool and Spa Please note – this does not turn off equipment. It only allows a user to toggle between the Pool thermostat and the Spa thermostat. “Up” Select to raise temperature set point or move up in a menu choice “Down” Select to lower temperature set point or move down in a menu choice “Mode” Select a mode Modes available are “ACH”, “COOL”, “HEAT”, and “OFF”. Please note – “ACH” and “COOL” only available on some models. Table 4 DISPLAY MESSAGE EXPLANATION SUPPLEMENTAL INFORMATION “000” A user lockout code has been activated. A numeric code is required before any temperature adjustment can be entered. Use the “UP” or “DOWN” arrow to enter code, then select “MODE” to temporarily unlock Heat Pump. If code is unknown, a re- set option is available in product manual. Manuals can be downloaded from “ACH” Auto-Change Over Mode When this mode is active, the heat pump will automatically switch between heating and cooling modes to maintain a set temperature point within 3 degrees. Feature available for Heat & Cool units. “COOL” Cooling Mode Heat Pump is set to cool the water. Feature available for Heat & Cool units. “HEAT” Heating Mode Heat Pump is set to heat water. “OFF” Unit off Heat Pump can be turned off by using “MODE” button or setting temperature below 45 degrees. Heat Pump will not allow a set temperature to be programmed until turned on again. “xx°” Current Water Temperature (Example 78°) Temperature can be set from 45° F to 104° F. This can be displayed in Fahrenheit or Celsius depending on programming. FLO No water flow through Heat Pump This can be a normal display depending on system settings. See “Troubleshooting” if needed. Table 5 PROGRAMMING Activity Steps Adjusting Temperature Step 1: Select the “POOL / SPA” button to choose the thermostat to adjust. Step 2: Select the “UP” or “DOWN” button to increase or decrease the desired set temperature. Step 3: Once set, the current water temperature will be displayed. The Heat Pump will start to operate to meet the desired temperature. Please note a time delay will be experienced if Heat Pump has just been initialized. This delay is between 4 to 5 minutes. Turning Heat Pump “ON” Step 1: Confirm Heat Pump has power. Step 2: Select the “MODE” button. Step 2: Using the “UP” or “DOWN” arrow, select “ACH”, “COOL”, “HEAT”, or “OFF”. See section on Display for “MODE” usage. Turning Heat Pump “OFF” Step 1: Select the “MODE” button. Step 2: Using the “UP” or “DOWN” arrow, select “OFF” Please note – setting temperature below 45° F will also turn off Heat Pump. Setting to “Celsius” or “Fahrenheit” Step 1: Select and hold down both the “UP” and “DOWN” arrow keys simultaneously until the Celsius / Fahrenheit code (CF1) appears on the display. Step 2: Select the “UP” or “DOWN” arrow to...

Herunterladen

Geben Sie zwei Ziffern: