Stimmen - 3, Durchschnittliche Bewertung: 4.3 ( )

Hersteller: Aquacal Dateigröße: 271.13 kb Dateiname: Unterrichtssprache:

CAUTION - Failure to heed the following may result in equipment damage. . Improper water chemistry can cause damage to pump, filter, pool shell, etc. To avoid equipment damage, maintain Pool/Spa water per standards detailed later in this manual. . Water flow exceeding max flow requires a bypass. Damage due to excessive water flow will void warranty. SAVE THESE INSTRUCTIONS SPECIFICATIONS Specification Description Electrical Service See data plate attached to front cover or behind front access panel on equipment. Water Flow Requirements 30 - 55 gallons per minute (gpm) ideal range. A heater bypass is required for water flow greater than 70 GPM flow. Exception: 035, 055, and 075 with a revision letter of B or higher have a 20-45 GPM range, with a max of 45 GPM. Table 1 STANDARDS Standards* Title Article 440 Standard for Safety for Electric Spas, Equipment Assemblies, and Associated Equipment. Article 680 Standard for Safety for Swimming Pool Pumps, Filters and Chlorinators. IEC 60335-1-2001 Household and similar electrical appliances - Safety - General requirements IEC 60335-2-40 2006 Household and similar electrical appliances - Safety – Particular requirements for electrical heat pumps, air- conditioners and dehumidifiers. NFPA 70 The electrical installation must conform to the current version of the NEC, and all applicable local and state codes. UL1995 Heating and cooling equipment. * Not all standards are applicable in all installations. Follow all local applicable codes. Table 2 SECTION 2 - INSTALLATION For commercial or complete installation instructions please, visit for equipment manual. EQUIPMENT CLEARANCES Keep the area immediately adjacent to the heat pump clear of items such as shrubs and bushes, lawn furniture, chemicals containers, etc. These items can prevent air from circulating properly through the heater, and will result in inefficient operation and/or damage to the heat pump. Figure 1 Figure 2 Overhang with Gutter 5 feet Minimum Clearance Overhead Rain Run-Off Must Be Directed Away From Heater (Front) 30” Minimum Clearance (Rear) 12” Clearance for all IceBreaker / Heat & Cool Models 12” Clearance for All Tropical Models 6” Clearance for SQ “Heat Only” Models (Rear) 12” Clearance for All IceBreaker / Heat & Cool Models 12” Clearance for All TropiCal Models 6” Clearance for SQ “Heat Only” Models (Side) 12” (Side) 12” (Front) 30” PLUMBING SCHEMATIC 3 = Three-Way Valve B = Bypass Check Valve (5lb) for Water Flow Over Max Flow (see Specifications for details) C = Chlorinator D = Main Drain F = Filter H = Heat Pump P = Water Pump R = Return S = Skimmer Figure 3 F P 3 S D POOL R C B H ELECTRICAL REQUIREMENTS 1) Locate the equipment power disconnect within 6-feet of the heater’s electrical enclosure. 2) Never mount power disconnects directly to heat pump. 3) Only use copper conductors. 4) Use sequencing controllers when multiple heaters are installed on site. 5) Local codes and regulations may require the use of a ground ...

Herunterladen

Geben Sie zwei Ziffern: