Stimmen - 4, Durchschnittliche Bewertung: 4.5 ( )

Hersteller: Aquacal Dateigröße: 271.13 kb Dateiname: Unterrichtssprache:

“xx°” Current Water Temperature (Example 78°) Temperature can be set from 45° F to 104° F. This can be displayed in Fahrenheit or Celsius depending on programming. FLO No water flow through Heat Pump This can be a normal display depending on system settings. See “Troubleshooting” if needed. Table 5 PROGRAMMING Activity Steps Adjusting Temperature Step 1: Select the “POOL / SPA” button to choose the thermostat to adjust. Step 2: Select the “UP” or “DOWN” button to increase or decrease the desired set temperature. Step 3: Once set, the current water temperature will be displayed. The Heat Pump will start to operate to meet the desired temperature. Please note a time delay will be experienced if Heat Pump has just been initialized. This delay is between 4 to 5 minutes. Turning Heat Pump “ON” Step 1: Confirm Heat Pump has power. Step 2: Select the “MODE” button. Step 2: Using the “UP” or “DOWN” arrow, select “ACH”, “COOL”, “HEAT”, or “OFF”. See section on Display for “MODE” usage. Turning Heat Pump “OFF” Step 1: Select the “MODE” button. Step 2: Using the “UP” or “DOWN” arrow, select “OFF” Please note – setting temperature below 45° F will also turn off Heat Pump. Setting to “Celsius” or “Fahrenheit” Step 1: Select and hold down both the “UP” and “DOWN” arrow keys simultaneously until the Celsius / Fahrenheit code (CF1) appears on the display. Step 2: Select the “UP” or “DOWN” arrow to select “1” for Fahrenheit or “2” for Celsius. Step 3: Allow display to time-out. Switching from Pool to Spa Select the “POOL / SPA” button. Table 6 SECTION 4 - MAINTENANCE POOL CHEMISTRY Maintain pool water with the following chemical levels. Commercial applications may vary from depending on locale. All values show in PPM (Parts Per Million). Chemical Pool Spa Chlorine 1 to 3 parts per million (PPM) 1.5 to 3 PPM Bromine 1 to 3 PPM 3 to 5 PPM pH 7.4 to 7.8 PPM 7.2 to 7.8 PPM Total Alkalinity 80 to 140 PPM 80 to 120 PPM Calcium Hardness 200 to 400 PPM 200 to 400 PPM Total Dissolved Solids 1,000 to 2,000 PPM 1,500 to 2,000 PPM Table 7 WINTERIZING In areas where freezing conditions are a rare occurrence, allow the filtration system to run continuously throughout the freeze period. Typically, during light freeze conditions, circulating (moving) water will not freeze. In areas where freezing conditions are prevalent and sustained, the heat pump must be winterized as follows: 1) Disconnect all electrical power to the heater; turn off circulating pump. 2) At the two (2) connection unions, disconnect the plumbing to the heater (removal is counter-clockwise). 3) If your unit has an external drain plug, remove plug. This plug would be located at lower, front corner of heater (position may vary between models). Allow water to drain out of the condenser. Replace the winterizing plug by threading the plug in clockwise until just snug, then apply an additional 1/8 turn. 4) If no drain plug is found, unit is self draining from unions. Check online manuals for appropriate winterizing ...

Herunterladen

Geben Sie zwei Ziffern: