Stimmen - 5, Durchschnittliche Bewertung: 4.6
(
)
)
|
Dieses Gerät hat auch andere Anweisungen:
Anleitung Zusammenfassung
Playback Record turned on turned on • The above indicates that Track 1 will play back while Track 2 is being recorded to. Real-time Recording to Track 1 With real-time recording, the notes and chords you play on the keyboard are recorded as you play them. To record to Track 1 using real-time recording 1 Use the SONG MEMORY button to enter record standby. Rec. No . Flash 2 Use [+] and [–] to select 0 or 1 as the song number. • The track is not yet selected at this point. • The above song number screen remains on the display for about five seconds. If it disappears before you have a chance to select a song number, use the SONG MEMORY button to display it again. Song number 3 Press the TRACK 1 button to select Track 1. • The “L” flashes on the display to indicate the track that will be recorded to. Flash 4 Make any of the following settings if you want. • Tone number (page E-19) • Rhythm number (page E-34) • MODE switch (page E-35) • If you are not confident about playing at a fast tempo, try using a slower tempo setting (page E-35). 5 Press the START/STOP button to start real-time recording to Track 1. 6 Play something on the keyboard. • Any melody and accompaniment you play on the keyboard (including Auto Accompaniment chords played on the accompaniment keyboard) is recorded. • If you use a pedal during recording, pedal operations are also recorded. [+] / [–] E-42 642A-E-044A LK55_e_41-45.p65 42 03.10.7, 5:30 PM Song Memory Function 7 Press the START/STOP button to end recording when you are finished playing. • If you make a mistake while recording, stop the record operation and begin over again from step 1. NOTE • Using real-time recording to record to a track that already contains recorded data replaces the existing recording with the new one. T rack 1 Contents After Real-time Recording In addition to keyboard notes and accompaniment chords, the following data is also recorded to Track 1 during real- time recording. This data is used whenever Track 1 is played back. • Tone number • Rhythm number • INTRO, SYNCHRO/ENDING, NORMAL/FILL-IN, VARIATION/FILL-IN button operations • Pedal operations Memory Capacity The keyboard has memory for approximately 5,100 notes. You can use all 5,100 notes for a single song, or you can divide memory between two different songs. • The measure number and note number flash on the display whenever remaining memory is less than 100 notes. Flash • Recording automatically stops (and Auto Accompaniment and rhythm stops playing if they are being used) whenever memory becomes full. Memory Data Storage • Anything previously stored in song memory is replaced whenever you make a new recording. • Memory contents are retained as long as the keyboard is supplied with electrical power. Unplugging the AC adaptor when batteries are not loaded or when loaded batteries are dead cuts off the keyboard’s electrical power supply, causing all data stored in song memory to be deleted. Be sure to plug the keyboard into an electrical outlet with the AC adaptor before replacing batteries. • Turning off the keyboard while a record operation is in progress causes the contents of the track you are currently recording to be lost. T rack 1 Real-time Recording V ariations The following describes a number of different variations you can use when recording to Track 1 using real-time recording. All of these variations are based upon the procedure described under “To record to Track 1 using real-time recording” on page E-42. To record without rhythm Skip step 5. Real-time recording without rhythm starts when you press a keyboard key. To start recording with synchro start In place of step 5, press the SYNCHRO/ENDING button. Auto Accompaniment and recording will both start when you play a chord on the accompaniment keyboard. To record using an intro, ending, or fill-in During recording, the INTRO, SYNCHRO/ENDING, NORMAL/FILL-IN, and VARIATION/FILL-IN buttons (pages E-38 through E-40) can all be used as they normally are. To synchro start Auto Accompaniment with an intro pattern In place of step 5, press the SYNCHRO/ENDING button and then the INTRO button. Auto Accompaniment will start with the intro pattern when you play a chord on the accompaniment keyboard. To start Auto Accompaniment part way into a recording In place of step 5, press the SYNCHRO/ENDING button and then play something on the melody keyboard to start. When you reach the point where you want Auto Accompaniment to start, play a chord on the accompaniment keyboard. 642A-E-045A E-43 LK55_e_41-45.p65 43 03.10.7, 5:30 PM E-44 Playing Back from Song Memory Use the following procedure to play back song memory contents. To play back from song memory 1 Use the SONG MEMORY button to enter playback standby, and then use [+] and [–] to select 0 or 1 as the song number. • The above song number screen remains on the display for about five seconds. If it disappears before you have a chance to select a song number, use the SONG MEMORY button to display it again. 2 P...
Dieses Handbuch ist für folgende Modelle:Musikinstrumente - LK-55 (4.79 mb)