Stimmen - 3, Durchschnittliche Bewertung: 4.3 ( )

Hersteller: Kenwood Dateigröße: 1.8 mb Dateiname: Unterrichtssprache:

Selection of reverse mode (Main unit only) REV. MODE Each press switches the modes as follows. 1 “ ” .... Playback stops after having played both sides of tape in a deck. (Relay play : .) 2 “ ” ... Endless playback of both sides of tape. 3 “ ”...... Playback stops after having played one side of tape. XD-SERIES (En) Selection of Tape Equalizer (Main unit only) (XD-4....series only) Select Tape Equalizer only when playing back a tape recorded with Dolby Noise Reduction. (A tape recorded without Dolby NR cannot be reproduced in normal audio if Tape Equalizer is selected when playing it.) Lights up when Tape Equalizer is on. TAPE EQ. Each press switches the modes as follows. 1 “T. EQ” ON ..... Tape Equalizer is used 2 “T. EQ” OFF ....... Tape Equalizer is not used . The Tape Equalizer is effective for reduction of higher-frequency noise. To stop playback & A #A # O Do not take out the cassette tape until the tape transport has stopped completely. Basic section O Normal (TYPE ), high (TYPE ), or metal (TYPE ) tape selection is set automatically. O Remove tape slack before loading. O Close the door securely. XD-5....series XD-4....series Reverse mode indication. Lights up when a tape is present in the deck in use. Displays the selected deck. O If the tape transport direction is opposite to the desired direction, press the play key corresponding to this. The indicators (2 , 3) indicate the current direction in which the tape advances when playback or record- ing is started automatically by the one-touch opera- tion function, etc. This direction is the direction stored in memory when the tape was last stopped. (To switch the tape transport direction, press the play key corresponding to the desired direction then press the stop (&) key.) Transport direction indicators Tape direction indicators of currently selected deck. XD-4....seriesXD-5....series 24 Let's put out some sound 24 Let's put out some sound XD-SERIES (En) Basic section A tip for use of the tape counter The tape counter is set to “0000” when a cassette tape is loaded. By writing down the counter reading in case you want to interrupt recording (playback) in the middle of the tape, the memo will be helpful as a ref- erence for locating the same position when continu- ing the recording (playback) the next time. The tape counter figure decrements during recording or play- back of the back side (while the 2 tape transport in- dicator is lit). To set the tape counter to “0000”, open the cassette holder once. Then the counter will be reset. T0APE 000 Relay play O Relay play is not possible in the reverse modes “ ” and “ ”. O If a tape is loaded only in either deck, playback stops after having played both sides of the tape. When tapes are set in the decks A and B and the re- verse mode is set to “ ” (play of both sides), play of the second deck will be started automatically after play of the first deck has been completed. Tape play will be repeated alternately. AA 25Let's put out some sound 25Let's put out some sound XD-SERIES (En) Searching for the desired music program (DPSS)(XD-5....series only) The DPSS (Direct Program Search System) is capable of detecting non-recorded spaces of more than 4 seconds as “blanks between programs” and, based on this information, can return to the beginning of the music program being played or the beginning of a desired program by skipping up to 16 other programs. During play in direction 3 To play the next program : Press once. To play the 4th program after the current program : Press 4 times. 1 @ & A # To return to the beginningof the current program : Press once. To play the 4th program before the current program : Press 5 times. During play in direction 2 To return to the beginningof the current program : Press once. To play the 4th program before the current program : Press 5 times. Basic section 1 @ & A # To play the next program : Press once. To play the 4th program after the current program : Press 4 times. The DPSS may not function normally with the following kinds of tape. O Tapes containing several no-sound intervals of more than 4 seconds, such as conversation and talk tapes. O Tapes containing pianissimo sections, such as classical music tape. O Tapes in which large noise is recorded in blanks between programs. O Tapes containing blanks between programs that are shorter than 4 seconds. O Tapes recorded at low level. O Tapes recorded by cross-fade recording (in which the beginning of next program is overlapped on the end of previous program). NotesNotes 26 Let's put out some sound 26 Let's put out some sound XD-SERIES (En) Receiving broadcast station Basic section1. Select the broadcast band. Collective presetting of stations One-by-one presetting Each press changes the band. It is also possible to receive them by one-touch operations by storing up to 30 stations in the pre- set memory. 2. Selecting the tuning mode When the BAND key is pressed, this unit will be switched on automatically. 4. 1 TUNING A BAND TUNING ...

Herunterladen

Geben Sie zwei Ziffern: