Moisture could accumulate in electrical components, danger of electrical shock! Hot vapours can lead to the damage of plastic parts. • The appliance must be dry before it is placed back into service. Important! • Ethereal oils and organic solvents can attack plastic parts, e.g. – lemon juice or the juice from orange peel; – butyric acid; – cleansers which contain acetic acid. Do not allow such substances to come into contact with appliance parts. • Do not use any abrasive cleansers. Clean the ap

This will reduce the possibility of a malfunction in the cooling system from handling during transportation. ? Clean the interior surface with lukewarm water using a soft cloth. • Installation of Your Appliance ? Place your refrigerator-freezer on a floor that is strong enough to support the refrigerator freezer when it is fully loaded. To level your refrigerator-freezer, adjust the leveling legs at the bottom of unit. ? Allow 2 inches of space between the back and sides of the unit, which allow

If the information given there does not help, please do not perform any further repairs yourself. • Under no circumstance should you attempt to repair the appliance yourself. Repairs carried out by inexperienced persons may cause injury or serious malfunctioning. Contact your local AEG Service Force Centre. Disposal Appliance Packaging Information All materials are environmentally sound! They can be disposed of or burned at an incinerating plant without danger. About the materials: The plastics

• Alterations or changes to the freezer are not permitted for reasons of safety. • If you use the freezer in a commercial application or for purposes other than the freezing or frozen storage of foods, please observe all valid legal regulations for your application. Prior to initial start–up • Check the appliance for transport damage. Under no circumstance should a damaged appliance be plugged in! In the event of damage, please contact your supplier. Refrigerant The refrigerant isobutane (R600a)

The dimensions of the recessed installation area must correspond with those indicated in the figure. 600 550min. 600 Remove covering and adjust the + bracket locking nuts. Push the appliance into place. + The plug socket necessary for connection of the appliance to the electricity supply should be positioned, so that the plug is not placed in the recess. + Adjust height. + Mounting furniture door . Screw appliance into place. . Place the covering strip. 580 a = 100b = 150 25.80 A = 820B = 870 25

The audible warning sounds until the red temperature pilot light goes out or until the audible alarm is switched off by operation of the fast-freeze switch. The fast-freeze switch can be switched off when the red lamp has gone out. Starting up and temperature regulation . Turn the temperature regulator (1) in the direction of “1”. The green light (6) and the red light (5) come on, the audible warning sounds (if fitted), and the refrigeration motor starts up. . Additionally operate the fast-freez

. The appliance must be dry before it is placed back into service. Warning! . Ethereal oils and organic solvents can attack plastic parts, e.g. . lemon juice or the juice from orange peel, . butyric acid; . cleansers which contain acetic acid. Do not allow such substances to come into contact with appliance parts. . Do not use any abrasive cleansers. 1. Remove frozen food and the food from the refrigerator. Wrap frozen food in several layers of newspaper. Store it in a cool place, well covered.

Defrost freezer compartment and clean thoroughly (see section: "Cleaning and Care"). Then leave the lid open to avoid odours. Maximum capacity / Stacking limit To be able to store larger quantities or bulky products for freezing you can remove all the storage baskets. The appliance will still function safely if used in this way. Do not stack the products higherthan the lower edge of the plastic frame. Freezing Tip: To freeze fresh foods use the small freezing compartment on the right of the divi

Explain why you are not pleased. In most cases, this will solve the problem. Write down the model and serial numbers. You’ll find them on a plate located on the bottom outside wall of the refrigerator. Please write these numbers here: Date of Purchase Model Number Serial Number Use these numbers in any correspondence or service calls concerning your refrigerator. If you received a damaged refrigerator, immediately contact the dealer (or builder) that sold you the refrigerator. Save time

2 Accumulation of dust at the condenser increases energy consumption. For this reason carefully clean the condenser at the back of the appliance once a year with a soft brush or a vacuum cleaner. 818 14 33-01/5 Something not Working Before contacting your local service force centre, check the following points. Sympton Solution Check there is power at the socket No power to the appliance. Check there is not a power cut by checking the household lights. Check the fuse has not blown. Check the ambi