Stimmen - 2, Durchschnittliche Bewertung: 5 ( )

Hersteller: Amana Dateigröße: 260.31 kb Dateiname: Unterrichtssprache:

Instant mount models are designed for Windows 27.5 inch (699mm) to 36 inch (914mm) wide. 3. Mark the center of Window sill with pencil. 4. Insert Screws (Type A) into the sill bracket. 5. Attach Sill bracket to window sill using two Screws (Type B) by each bracket. The outside edge of window bracket should be 11.8 inch (300mm) from center line. 6. Adjust Screw (Type A) so that Sill Bracket have a slight tilt by using carpenter's level meter. Window Shutter (2 pieces) Window kit FrameLeft side (1 piece) Screw Type B SILL Screw Type A SILL BRACKET 300mm 600mm 699~914mm SASH • Step 3 - Preparation of Chassis 1. Pull the Air-filter out of the Front Grille. 2. Loosen screw which fasten Front Grille with driver. 3. Pull knobs out of the control. (when the knobs are too tight to release, leave them.) .............................................................................................................................. ................................................ 5 6 4. Disassemble Front Grille from Chassis. – Front Grille and chassis are fixed with snap-fit. 1) Release right-lower snap-fit. – Push the right lower side of chassis to the left, with pushing left side of Front Grille to the right until the snap-fit is released. 2) Release left-lower snap-fit. – Push the left-lower side of chassis to the right, with pushing right side of Front Grille to the right until the snap-fit is released. 3) Pull lower side of the Front Grille until it is separated from the chassis. (when knobe remain, pull Front Grille until knobs are released from control) 4) Push base side of the Front Grille to upper side until it is separated from the chassis. 5) After front grille is removed, remove two screws located in both side of chassis. 6) Grip the handle of base pan and pull out the unit from chassis. Push Push Push Push NOTICE: Do not remove any styrofoam because that is a part of the unit. • Step 4 - Placing Chassis 1. Insert narrow side of ‘Frame Guide Lower’ to rectangle holes located in bottom of chassis, and fasten it with Screw (Type E). 2. Insert Window Kit Frames to Top Guide and Lower Guide. 3. Fasten Shutter to side holes of Chassis with six Screws (Type E). 4. Place the chassis on the window sill and align it with Sill Bracket and sill with Lower Frame Guide and locate window sash to Top Frame Guide. (check the end of chassis for about 1/2 inches (12mm) distance below the level.) 5. Attach the Window seal B to Frame Guide Top. 6. Fasten Front Chassis Bracket to sill with three Screws (Type C). Screw (Type E, both side)FRAME Guide Lower Frame Guide Top Window Seal B 7. Fasten Sash Bracket with Screw (Type C) to top of indoor window sash or directly into side of window sash or directly into side of window frame. This will prevent raising of the window from the outside. If you have a hard Screw (Type E) wood or metal window frame, a 1/8 inch pilot hole may be needed in order to drive the screws. 8. Attach the Window Seal A to windo...

Herunterladen

Geben Sie zwei Ziffern: