Stimmen - 2, Durchschnittliche Bewertung: 4.5
(
)
)
|
Anleitung Zusammenfassung
Check fuse or circuit breaker Set FAN CONTROL to position other than "OFF" Inefficient or no cooling Dirty air filter Inappropriate capacity for application Blocked air flow Power interruption, settings change too quickly, or compressor overload tripped Clean or replace air filter Check with dealer to determine proper unit capacity for application Remove obstruction from grill or outdoor louvers Let fan run to restart compressor (in approximately 10 minutes ) Noisy unit Loose parts Inadequate support Tighten loose parts Provide additional support to unit Odors Formation of mold, mildew, or algae on wet surfaces Remove drain plug and drain base pan Replace drain plug Clean unit thoroughly Water dripping outside Condensation run-off is norma during hot and humid weather Add flexible tubing to redirect water flow, see (Fig 19) Water dripping inside Unit is not properly angled to allow water to drain outside Unit must be installed on an angle for proper condensation run-off Check the unit and make adjustments Ice or frost build-up Low outside temperature Unit air filter is dirty When outdoor temperature is approximately 65°F or below, frost may form when unit is in cooling mode Switch unit to FAN (only) operation until frost melts Remove and clean filter NOTE. 1 If circuit breaker is tripped repeatedly, or fuse is blown more than once, contact a qualified technician - 14 —...
Dieses Handbuch ist für folgende Modelle:Splitgeräte - 463AAC010BA (502.17 kb)