Stimmen - 0, Durchschnittliche Bewertung: 0
(
)
)
|
Dieses Gerät hat auch andere Anweisungen:
Anleitung Zusammenfassung
HP 203966 PN: D7140-80200 REV D FRONT SIDE 7.910 X 10.750 .130R DC 1522ALA SP 85/2400 OM
HP NetServer E60 Technical Reference Card
HP Product No. D7140-80200 Rev. D
Power Supply
A Cabinet/Front LEDs
Shelf 1: Flexible Disk
B Mass Storage Device Locations and Settings
Shelf 2: CD-ROM
Shelf 3: Optional Tape Drive
System Board
(Included in Certain Models)
Device
Location in order of
Device Settings
Shelf 4: Hard Disk Drive
recommendation
(Included in Certain Models)
Standard Hard Disk Drive
Shelf 4
SCSI ID 0 [Default]
(Model 9.1 GB)
Shelves 5, 6, 7
HP Accessory 4.2 GB HDD or
Shelf 5, 6, 7
For Additional HDD, Set to
Front LED Indicator
Unused SCSI ID
HP Accessory 9.1 GB HDD or
Below Shelf 3
HP Accessory 18.2 GB HDD
System Power Switch
HP SureStore T20i
Shelf 3
SCSI ID 4 [Default]
System Power Indicator
HP
SureStore DAT 8i or 24i
Shelf 3
SCSI ID 2 [Default]
Off-System is Off
Standard SCSI Controller
Embedded
SCSI ID 7
Solid Green-System is Running
Do not operate
Blinking Green-System is in
Standard IDE CD-ROM
Shelf 2
Set to Master [Default]
without air duct.
Sleep Mode
Hard Drive Activity Indicator
Video Card
Solid Yellow-IDE or
SCSI Activity
Slots for Inserting HD Drives
See documentation with each device for further configuration information.
C System Board
System Fan Connector
CPU Cage
Primary
CPU Slot
DIMMs
Secondary
Keyboard
CPU Slot
DIMM Installation
and Mouse
0 1 2 3
Cautions:
• Use Only HP unbuffered DIMMs
+
Power
Connector
• Any combination (mix or match) of up to four
CPU Module
Do not mix CPU types or speeds. Both CPU's must
be the same type and speed.
each of 64MB,128MB or 256MB DIMMs
Serial
Port1
• Order of Installation is Slot 0, 1, 2, 3
FDD
Terminator is required in secondary CPU slot when
second CPU is not installed.
LPT
The Air Duct and all covers and panels must be
System Switch Settings
Serial
IDE1
in place to provide controlled airflow for system
1 2 3 4 5 6 7 8
Port2
On
reliability.
450MHz
IDE2
Off
LAN
+
Off = "KBD Power On"
500MHz
Unused
550MHz
Video
68-pin
On = Clear Password
600MHz
SCSI-B
On = Clear Configuration
1
IRQ Sharing
68-pin
650MHz
2
SCSI-A
SCSI (A&B)
PCI 3
Emb NIC
PCI 4
PCI
3
PCI 1
PCI 5
Default Boot Order
Slots
4
PCI 2
PCI 6
1. IDE CD-ROM
6. PCI 1
Status
5
2. FDD
7. PCI 6
Panel
3. Embedded SCSI A
8. PCI 3
Connector
6
4. Embedded SCSI B
9. PCI 4
ISA Slot
5. PCI 2
10. PCI 5
System Switches
Battery
For additional information, see other side.
HP 203966 PN: D7140-80200 REV D BACK SIDE 7.910 X 10.750 .130R DC 1522ALA SP 85/2400 OM
HP NetServer E60 Technical Reference Card
HP Product No. D7140-80200 Rev. D
D Mass Storage Cabling/Rear LEDs
E
When removing the Power Supply,
Power Cabling
disconnect its four connectors from
the harness along dotted line. Retain
Power
Built-in SCSI Terminator
the other harness.
Receptacle
BP4
Shelf 1
FDD
Power Supply
Shelf 1
FDD
Unit
Shelf 2
CD-ROM
P1
Shelf 2
CD-ROM
A
Shelf 3
Reserved for Tape Drive
P2
Shelf 3
Reserved for
B
BP2
BP1
BP3
(Optional)
Tape Drive
BP2
BP1
BP3
C
Power Supply
P3
Shelf 4
Hard Disk Drive
Harness
FDD Connector
Shelf 4
Hard Disk Drive
Shelf 5
P4
(Some Models)
Shelf 5
ATX Connector
Reserved for
Primary IDE
Shelf 6
P5
Hard Disk Drives
Secondary IDE
Reserved for
Shelf 6
Shelf
Shelf 7 6
Hard Disk Drives
P6
Shelf 6
Shelf 7
SCSI B
SCSI A
Cables
Part Number
Rear LED Indicator
Flexible
A Disk
D7140-63006
On LAN Connector
Snap
Key to Mounting Screws
Cable
Activity Link Indicator
LAN Speed Indicator
IDE
+
Visible when Cables and Processors
Steady Green-Link Valid
OFF-10Mbps
B CD-ROM D7140-63005
LED
LED
have been Removed.
Blinking Green- Activity
Steady Yellow-100Mbps
Cable
SCSI
CPU Module
on LAN
C
D7140-63001
Cable
Not visible when Processor Installed.
Note: For complete instructions,
F
see the Information Assistant on the
Service Information
G Tips for Removing
HP Documentation CD-ROM.
the System Board
Electronic Support Services
+
• Internet Web Pages http://www.hp.com/netserver
• Unplug Power, Remove Cover
Audience Assumptions
• Internet FTP ftp://ftp.netserver.hp.com
• Retract Feet, Lay Unit on Right Side
This Technical Reference Card is for trained service
• CompuServe Library GO HPPC
• Swing Air Duct Open
personnel. Hewlett-Packard Company assumes you
• HP Navigator CD
1
are qualified in the servicing of computer equipment
• Disconnect All Cables
Support Questions
and trained in recognizing hazards in products with
2
from System Board
hazardous energy levels.
• HP-Authorized Reseller
• Take out CPUs (If Only One CPU
• CompuServe Discussion Forum GO HPPC
3
Electrostatic Discharge
Present, Also Remove Terminator
• US / Canada Phone Support 1-208-331-2767
4
To avoid catastrophic or hidden damage to components,
from Second Slot)
• Europe Phone Support (+31-20) 581-3330
wear a wrist strap and use a static-dissipative work
(Netherlands)
• Take out Video Card and
5
surface connected to the chassis when handling
HP has offices in over 100 countries. Check
All PCI or ISA Cards
components. Use an antistatic service kit, such as
6
your local telephone directory.
3M 8501/8502/8505 or equivalent.
• Remove All 11 Screws (See Illustration)
Optional HP 3 Year On-Site Support Pack
This information is subject to change without notice
• Grasp and Unsnap the Snaps
and is provided without warranty.
• H5525A Next Business Day
at Corners Opposite Back Panel
• H5517A Same Business Day
Snap
• Swing Edge Opposite Back Panel Outward
© Copyright 1999. Hewlett-Packard Company
• H5512A 7 day/24 hour
• Slide Board Out Carefully
For additional information, see other side.