Stimmen - 4, Durchschnittliche Bewertung: 3.8 ( )

Hersteller: Dell Dateigröße: 3.98 mb Dateiname: Unterrichtssprache:

Dieses Gerät hat auch andere Anweisungen:

PC Desktops - PowerEdge C410X (5.6 mb)

PC Desktops - PowerEdge C410X (5.78 mb)

PC Desktops - PowerEdge C410X (3.98 mb)

IPv6 is not backwards compatible with IPv4, and IPv4 hosts and routers will not be able to deal directly with IPv6 traffic. IPv6 has a significantly larger address space than IPv4. This results from the use of a 128-bit address, whereas IPv4 uses only 32 bits. When you finish the configuration, click Apply Changes. BMC Remote Management Console | 77 Email Settings If you want the alert to be sent by email, you can configure to specify the e-mail address, subject and message in the Email Settings. After you finish the configuration, click Apply Change to save the settings. BMC Remote Management Console | 78 Port Map User can identify the specified iPASS mapping to PCIE controller in Port Map. Click Apply Change to save the settings. BMC Remote Management Console | 79 Troubleshooting Your System Safety First—For You and Your System WARNING: Whenever you need to lift the system, get others to assist you. To avoid injury, do not attempt to lift the system by yourself. CAUTION: Before removing the system cover, turn off all power, then unplug the AC power cord, and then disconnect all peripherals, and all LAN lines. CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product. Symptom: iPass card / port not recognized by the system Check System Status (System must stay switched off) 3. Look at the back of each power supply. A green LED should be lit when AC power is applied. NOTE: Do not press power button on the system. 4. Check front panel LED (UID and Power LED). See figure 1 on Page 10 • ID and Power LED should not light at the beginning. • After 30 seconds or so, when BMC is ready, UID LED and Power LED blink once. 5. System power on and Power LED lights. Other PCIe devices will be powered on in 40 sec. Light green: PCIe device Power On 6. When PCIe cards are ready, power on the host system for test. Troubleshooting Your System | 80 Checking GPU Card 1. Power off and remove the middle cover. See section-Removing System Cover to remove the middle cover. 2. Power on the system and PCIe device and check if the GPU card LED lights. 3. If not, see Check iPass cable. Checking iPass Cable 1. Check if iPass cable is properly connected. 2. If the iPass cable is not plugged in correctly, power off the sytem and plug-in the iPass cable again. 3. If not, swap iPass cable. Troubleshooting Your System | 81 Checking iPass Connector to Host System 1. Check the Board to Board (BTB) connectors to the iPass Boards. 2. Check System SMBus device routing table. IPASS TOP IPASS Bottom iPass 1: Slot 1/15 iPass 5: Slot 2/16 iPass 2: Slot 3/13 iPass 6: Slot 4/14 iPass 3: Slot 5/11 iPass 7: Slot 6/12 iPass 4: Slot 7/9 iPass 8: Slot 8/10 Check if iPass Board (GS-IPASS2 / GS-IPASS3) is installed properly 1. See Replacing iPass Board on page 40 for instructions to accessing the iPass boards. 2. Reverse the steps above to reassemble the system. 3. Restart system and test again. Troubleshooting Your System | 82 Jumpers and Connectors Dell PowerEdge C410X Middle Board Connectors and Jumpers Figure 5 identifies critical components on the Dell PowerEdge C410X middle board. Figure 5 – Middle Board Connectors and Jumpers Item Component 1. PCI-E connectors 2. PCI-E connectors 3. Power connectors 4. iPass board connectors 5. Battery 6. Front I/O connector 7. FAN connectors 8. FAN LED connectors 9. Failover setting pin header Troubleshooting Your System | 83 Getting Help Contacting Dell For customers in the United States, call 800-WWW-DELL (800-999-3355). NOTE: If you do not have an active Internet connection, you can find contact information on your purchase invoice, packing slip, bill, or Dell product catalog. Dell provides several online and telephone-based support and service options. Availability varies by country and product, and some services may not be available in your area. To contact Dell for sales, technical support, or customer service issues: 1. Visit support.dell.com. 2. Click your country/region at the bottom of the page. For a full listing of country/region click All. 3. Click All Support from Support menu. 4. Select the appropriate service or support link based on your need. 5. Choose the method of contacting Dell that is convenient for you. Jumpers and Connectors | 84 Index back view, 3 cable routings, 51 checking GPU card, 77 checking iPass cable, 78 checking iPass connector, 79 checklist, 1 configuring IPMI, 61 network, 57 security, 58 services, 60 sessions, 63 user, 59 email settings, 75 firmware updates, 64 front I/O removing, 46 front view, 2 getting help contacting Dell, 82 GPU power consumption, 70 initial configuration via DHCP server, 53 iPass board replacing, 35 iPass port mapping, 52...

Herunterladen

Geben Sie zwei Ziffern: