Stimmen - 3, Durchschnittliche Bewertung: 4 ( )

Hersteller: Monessen Hearth Dateigröße: 1.06 mb Dateiname: Unterrichtssprache:

The appliance may be located on or near conventional construction materials. However, if installed on combustible materials, such as carpeting, vinyl tile, etc., a metal or wood barrier covering the entire bottom surface must be used. NOTE: DIAGRAMS & ILLUSTRATION ARE NOT TO SCALE. ASSEMBLY STEPS Notes: • Illustrations shown in this manual reflect “typical” installations with nominal dimensions and are for design and framing reference only. Actual installations may vary due to individual design preferences. However, always maintain minimum clearances to combustible materials and do not violate any specific installation requirements. Refer to the Framing Specifications Figures on Page 11. • The following steps represent the normal sequence of installation. Each installation is unique, however, and might require a different sequence. Step 1. Position firebox prior to framing or into prepared framing. Step 2. Field wire the main power supply to the appliance if a blower kit is to be installed (at the time of installation or a later date). An optional junction box kit and blower kit is required (see Page 15 for ordering information). Follow the installation and wiring instructions on Pages 12 through 14). Electrical connections should only be performed by an experienced, licensed/certifi ed tradesman. Step 3. Plumb gas line. (Gas connections should only be performed by an experienced, licensed/certifi ed tradesman). Step 4. Install decorative type Vent-Free room heater per the instructions provided with the Vent-Free room heater. Step 5. Complete finish wall material, surround and optional hearth extension to your individual taste. INSTALLATION Gas Line Installation CAUTION Plumbing connections should only be performed by a qualifi ed, licensed plumber. Main gas supply must be off when plumbing gas line to fireplace or performing service. Consult all local codes. Properly size and route the gas supply line from the supply regulator to the area where the appliance is to be installed per requirements outlined in the National Fuel Gas Code, NFPA 54 - latest edition (USA) or B149 - latest edition (Canada). Never use galvanized or plastic pipe. Gas lines must be routed, constructed and made of materials that are in strict accordance with local codes and regulations. We recommend that a qualified individual such as a plumber or gas fitter be hired to correctly size and route the gas supply line to the appliance. Installing a gas supply line from the fuel supply to the appliance involves numerous considerations of materials, protection, sizing, locations, controls, pressure, sediment, and more. Certainly no one unfamiliar and unqualified should attempt sizing or installing gas piping. Remove the gas line access cover plate on either the left or right side of the fireplace (see Figure 8 showing locations). Install 1/2" min. to 1-1/2" max. inside diameter approved gas line through the firebox wall for connection to the Vent-Free...

Herunterladen

Geben Sie zwei Ziffern: