Stimmen - 3, Durchschnittliche Bewertung: 3.7 ( )

Hersteller: Monessen Hearth Dateigröße: 2.39 mb Dateiname: Unterrichtssprache:

HOOD INSTALLATION Refer to Figure 35. All models must have hoods installed prior to operating. On louvered face units, slide the hood into the slots on the lower edge of the cabinet top above the louvered vent (see Figure 35). STEP 14. FINISHING REQUIREMENTS Wall Details Complete fi nished interior wall. To install the appliance facing fl ush with the fi nished wall, position framework to accommodate the thickness of the fi nished wall (see Figure 9 on Page 8). See Page 4 for Cold Climate Insulation and Page 8 for Clearances. Figure 35: Louver Face Models Combustible Finished Wall Materials Min. 1 in. (25 mm) This area must remain clear of combustible materials. Combustible material may touch top of appliance. Combustible materials NOT allowed below this point on face of appliance. Header Spacing Top Standoff Top of Appliance Top of Door Frame Hood must be installed as shown. Louvers NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. LENNOX HEARTH PRODUCTS • MERIT PLUS® B-VENT GAS FIREPLACES (MPB33/35/40/45) • INSTALLATION INSTRUCTIONS STEP 15. ATTACHING SAFETY-IN-OPERATION WARNINGS It is the installer’s responsibility to ensure these warnings are properly affixed during installation. These warning labels are a critical step in informing consumers of safe operation of this appliance. ATTACHING SAFETY IN OPERATION WARNINGS It is required that the safety instruction labels furnished with the fireplace be affixed to the operation and control point of the fireplace. A safety instruction label must be affixed to the wall switch plate where the fireplace is turned on and off (See Figure A) and if used on the remote control handheld transmitter (Figure B). To properly complete the installation of this fireplace, locate the multi-lingual adhesive labels provided with the Care and Operation Instructions and proceed as follows: 1. Locate the wall switch that controls the fireplace (verify the switch operates the fireplace by turning it on and off). Clean the wall switch plate thoroughly to remove any dust and oils. Affix the label to the surface of the plate of the wall switch that controls the fireplace (Figure A). Choose the language primarily spoken in the home. If unknown, affix the English language label. 2. If a remote control is used to control the fireplace, locate the transmitter and clean it thoroughly to remove any dust and oils. Affix the label to the surface of handheld transmitter (Figure B). Choose the language primarily spoken in the home. If unknown, affix the English language label. 3. If you are unable to locate the labels, please call Lennox Hearth Products or your nearest Lennox Hearth Products dealer to receive additional safety instruction labels free of charge. Cat. No. H8024 Replacement Label Kit LENNOX HEARTH PRODUCTS 1-800-655-2008 Note: English is red text on clear label. French and Spanish are white text on black label. SAFETY LABEL DIAGRAMS Illustrations are for example only. Your accessories may be different. Les illustrations ...

Herunterladen

Geben Sie zwei Ziffern: