Stimmen - 2, Durchschnittliche Bewertung: 5 ( )

Hersteller: Lennox International Inc. Dateigröße: 2.39 mb Dateiname: Unterrichtssprache:

In addition, when the unit is recessed, the side walls surrounding the unit must not extend beyond the front edge of the unit (see Figure 3). Back 1/2 (13) Sides 1/2 (13) Top Spacers 0 (0) Floor 0 (0) Bottom of Appliance To Ceiling 64 (1626) Vent 1 (25.4) SERVICE CLEARANCES Feet (meters) Front 3 ft. (0.9 m) Table 5: Minimum Clearances [inches (millimeters)] HEARTH EXTENSION A hearth extension is not required with this appliance. If a hearth extension is used, do not block the control compartment panel. Any hearth extension used is for appearance only and does not have to conform to any requirements for thermal protection. WALL FINISHES / SURROUNDS / MANTELS Note: Combustible wall finish materials and/ or surround materials must not be allowed to encroach the area defined by the appliance front face (black sheet metal). Never allow combustible materials to be positioned in front of or overlapping the appliance face (see Figure 35 on Page 21). Non-combustible materials, such as surrounds and other appliance trim, may be installed on the appliance face with these exceptions: they must not cover any portion of the removable glass panel, louvers, or control compartment. Figure 5: Minimum Mantel Clearances 12 (305) MANTEL 10 (254) MANTEL 8 (203) MANTEL 6 (152) MANTEL 4 (102) MANTEL 4 (102) 14 356) 12 (305) 10 (254) 2 (51) MANTEL TOP OF APPLIANCE6 (152) NOTE - Hood shown as positioned in louvered front model. The hood position in the flush faced front model is lower than shown. 8(203) MANTEL CLEARANCES Inches (mm) Vertical installation clearances to combustible mantels vary according to the depth of the mantel (See Figure 5). Mantels constructed of non-combustible materials may be installed at any height above the appliance opening; however, do not allow anything to hang below the fi replace hood. NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. 0” Clearance to Combustible Side Wall Ceiling 64 in. (1626 mm) Bottom of Fireplace Figure 6: Clearance References WARNING Failure to position the parts inaccordance with these diagramsor failure to use only parts specifically approved with this appliancemay result in property damage orpersonal injury. Minimum clearance requirements include any projections such as shelves, window sills, mantels, etc. above the appliance. NOTE: We recommend the use of high temperature paint (rated 175 °F, or higher) on the underside of the mantel. AVERTISSEMENT Risque de dommages ou deblessures si les pieces ne sontpas installees conformement aces schemas et ou si des piecesautres que celles specifi quementapprouvees avec cet appareil sontutilisees. LENNOX HEARTH PRODUCTS • MERIT PLUS® B-VENT GAS FIREPLACES (MPB33/35/40/45) • INSTALLATION INSTRUCTIONS PRE-INSTALLATION STEPS The appliance is shipped with all gas controls and components installed and pre-wired. Before installing the appliance, follow these steps: 1. Remove the shipping carton. 2. Remove the shipping pad, exposing the front glass door. 3. Open the spring latch securi...

Herunterladen

Geben Sie zwei Ziffern: