Stimmen - 3, Durchschnittliche Bewertung: 4.3 ( )

Hersteller: Lennox Hearth Dateigröße: 1 mb Dateiname: Lennox_Superior_VF-4000_Installation_Operation_903590.pdf Unterrichtssprache:

VF4000 SPECIFICATIONS 37" (940 mm) 31-1/2" (800 mm) 30" (762 mm) 15" (381 mm) 36" (914 mm) Front View 5-1/2" (140 mm) 37" (940 mm) 31-1/2" (800 mm) J Box Opening Gas Line Opening 8" (203 mm) 3-3/4" (95 mm) 3-1/2" (89 mm) 1/2" (13 mm) 3" (76 mm) 15-1/2" (394 mm) Left Side View (Right Side View - Opposite) 27" (686 mm) 15-1/2" (394 mm) 36" (914 mm) Top View Figure 21 NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. VF4000-CHM/P OPERATING INSTRUCTIONS (STANDARD VALVES) FOR YOUR SAFETY READ BEFORE LIGHTINGLIGHTING INSTRUCTIONS1.Stop! Read the safety information above. 2.Make sure manual shut-off valve is fully open. 3.Locate gas control knob and piezo. 4.Depress control knob in and turn clockwise to the“OFF” position (Figure 22). 5.Wait 5 minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow “B” inthe safety information above. If you do not smell gas, go to thenext step. 6.The pilot is located on the right side in front of the burner(Figure 23). 7.Depress control knob in and turn counterclockwiseto the “IGN” position (Figure 24). Press the control knob allthe way in for 5 seconds. Note:If you are running the heater for the first time it will benecessary to press the control knob all the way in for 30seconds to allow air to bleed out of the gas piping. MANUAL MATCH LIGHTING PROCEDURE — EMERGENCY ONLY1.If the pilot cannot be lit with the piezo igniter, the heater can bemanually lit with a match. 2.With the right hand, depress and turn the control knobcounterclockwise to the “ON” position. Hold in theknob. TO TURN OFF GAS TO HEATER1.Depress and turn control knob clockwise to the “OFF” position (Figure 22). 3.Light the match and hold the flame to the end of the pilot andignite the pilot. 4.Continue to hold control knob for an additional 10 seconds toinsure pilot remains lit. 5.Release the control while turning control knob to desiredsetting. 8.With the control knob pressed in, push in and release thepiezo igniter button to light the pilot. 9.Hold the control knob in for a further 10 seconds to preventthe flame failure detector from shutting off the gas while theprobe is warming up. 10.Release the control knob while turning counterclockwise to the "HI" or "LOW" Position. •If the knob does not pop out when released, stop andimmediately call your service technician or gas supplier. •If the pilot will not stay lit after several tries, depress andturn the gas control knob clockwise to “OFF” and wait 30 seconds. Depress and turn knob counter- clockwise to “IGN” andpress igniter button again. If your pilotdoes not relight depress and turncontrol knob clockwise to“OFF” and call your service technicianor gas supplier. 11.Wait 30 seconds before readjusting the heater when thecontrol knob has been turned down to a lower setting. •Immediately call your gas supplier from a neighbor’sphone. Follow the gas supplier’s instructions. •If you cannot reach your gas supplier, call the firedepartment. C.Use only your hand to pus...

Herunterladen

Geben Sie zwei Ziffern: