Stimmen - 2, Durchschnittliche Bewertung: 3 ( )

Hersteller: Cadet Dateigröße: 209.41 kb Dateiname: Unterrichtssprache:

4. To prevent possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces, like a bed, where openings may become blocked. Heaters must be kept clean of excessive lint, dirt and debris. (See Maintenance Instructions). 8. Use extreme caution when any heater is used near children or invalids and whenever the heater is left operating unattended. 9. WARNING Do not operate after heater malfunctions or has been dropped or damaged in any manner. 10. WARNING Risk of fire. Do not block heater minimum of 12 inches in front and above, 6 inches on both sides. 11.Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electrical shock, or injury to persons. 12.Verify that the electrical supply wires are the same voltage as the heater. The heater must be grounded to the grounding screw provided. If you need to install a new circuit or need additional wiring information, consult a qualified electrician. SAVE THESE INSTRUCTIONS Tel: 360-693-2505 P.O. Box 1675 Vancouver, WA 98668-1675 INSTALLATION INSTRUCTIONS INSTALLATION INSTRUCTIONS All electrical work and materials must comply with the National Electric Code (NEC), the Occupational Safety and Health Act (OSHA), and all state and local codes. ABOUT THE CADET SOFTHEAT ELECTRIC BASEBOARD: The Cadet Softheat Baseboard is designed to provide zonal heat to a room by using convection to naturally circulate warm air. Safety is Cadet’s first priority. All Softheat baseboards feature an oversized high temperature auto reset limit switch that shuts the heater off when excessive operating temperatures are detected. For effective and safe operation, and to prolong the life of the heater, read all instructions and safety information, and follow the maintenance instructions in this Owner’s Guide. BEFORE PROCEEDING WITH THE INSTALLATION INSTRUCTIONS, YOU MUST CONSIDER SEVERAL FACTORS THAT ARE CRITICAL TO INSTALLATION THERMOSTAT A thermostat is required. A Cadet wall thermostat is recommended for optimum performance, or you may prefer the convenience of a built-in EBKN DPST thermostat kit. For instructions on wiring a thermostat, see the instructions that were included with your thermostat. If you are installing a thermostat, refer to the section later in this guide titled “Step 3: Thermostat” prior to installing the baseboard. PLACEMENT For best results, install the Softheat baseboard heater under a window, along an outside wall, or as close as possible to an outside door. Follow these instructions for selecting an ideal area of installation: DO NOT INSTALL ANY BASEBOARD BELOW AN ELECTRICAL OUTLET DO NOT INSTALL ANY BASEBOARD VERTICALLY. MOUNT THE BASEBOARD HORIZONTALLY ONLY WARNING Do not mount the heater against combustible low-density cellulose fiberboard. WARNING To reduce risk of fire, do not store or use gasoline or other flammable vapors and liquids in the vicinity of the heater. • The seam at the junction of t...

Herunterladen

Geben Sie zwei Ziffern: