Stimmen - 1, Durchschnittliche Bewertung: 5 ( )

Hersteller: Cadet Dateigröße: 209.41 kb Dateiname: Unterrichtssprache:

2. Replace element or heater. Heater not working 1. Heater does not have proper voltage to function correctly 2. Unit wired incorrectly 1. Circuit breaker could be positioned incorrectly. Relocate breaker. Check voltage at the heater between supply wires and make sure it matches required heater voltage. 2. Using Owner’s Guide, verify wires are connected properly and securely with appropriate wire nuts. If the unit is still not operating, further testing should be done with ohmmeter. Consult an electrician. Liquid found in or around unit 1. Heat transfer fluid may be escaping from element 1. Immediately discontinue use.* Replace element or heater (elements are not repairable). Room does not heat quickly 1. Unit is slow to heat 2. Unit wired incorrectly 1. No solution necessary - typical initial warm-up takes 30-60 minutes. 2. Check voltage at the heater between supply wires and make sure it matches required heater voltage. Heater will not shut off 1. Heat loss from room is greater than heater capacity 2. Defective thermostat 3. Thermostat wired incorrectly to heater 1. Close doors and windows. Provide additional insulation, install a higher-wattage heater or multiple heaters, if necessary. 2. Adjust thermostat to its lowest setting. If heater continues to run (allow two minutes for the thermostat to respond), replace thermostat. 3. Refer to thermostat documentation and correct wiring. * What to do if the solution in your Softheat Baseboard should leak out: The solution in your Softheat Baseboard is a non-toxic thermal fluid (Material Safety Data Sheet available upon request). This solution is non-toxic if ingested, and there is no immediate health concern with air quality following a spill. Take adequate precautions to keep people and animals away from leakage. Non-porous rubber gloves and eye protection should be worn during clean-up if exposure and contact lasts longer than two hours. Soak up spill with an absorbent material such as paper towels. Once excess liquid or residue has been absorbed, a non-oxidizing cleanser such as an orange citrus cleaner can be used to remove any remaining dried residue (first test a hidden section of flooring for colorfastness). Scrub spill area, then use absorbent material to remove any remaining cleanser. Several applications of the cleanser may be required, depending on size and amount of spill. WARRANTIES Maintenance: For more effective and safer operation and to prolong the life of the heater, read the Owner’s Guide and follow the maintenance instructions included with each heater. Failure to properly maintain the heater will void any warranty and may cause the heater to function improperly. Warranties are non transferable and apply to original consumer only. Warranty terms are set out below. LIMITED ONE-YEAR WARRANTY: Cadet Manufacturing Co. will repair or replace any Cadet product, including thermostats, found to be defective or malfunctioning from first date of purchase through the first year. LIMITED SEVE...

Herunterladen

Geben Sie zwei Ziffern: