Stimmen - 4, Durchschnittliche Bewertung: 4.3 ( )

Hersteller: Black & Decker Dateigröße: 232.54 kb Dateiname: Unterrichtssprache:

Plug into an AC outlet. For 100HF, 101HF models, choose HIGH for large rooms and LOW for smaller rooms. For 200HF, 201HF, 300HF, 301HF and BDHF200T models with room select, turn room select dial to the appropriate setting for a small (approx. 10'x10'/3m x3m), medium (approx. 12'x12'/3.8m x3.8m) or large room (approx. 12'x 16'/3.8m x5m) (B). 2. Turn thermostat control to HOT to activate heater/fan. Once desired room temperature is achieved, turn thermostat control toward FROST WATCH until fan cycles off. The heat will now cycle on/off to maintain a comfortable level. 3. To use as a fan without heat, move dial to FAN ONLY and thermostat control toward HOT until fan begins to operate. No heating will occur in this mode. 4. The POWER indicator light shows heater is switched on and operating. It continues to glow even if the thermostat has cycled and the heating elements are off. Even though this unit has a cool-touch housing, both the front and back grilles will get hot. Be careful not to touch them. 5. Frost watch: When heater is plugged in and POWER indicator light is on, you can select any setting for room size (depending on your model) and leave thermostat control on the lowest setting. Your heater/fan will remain off unless temperature drops below (40° F/4°C). If this happens, FROST WATCH will automatically cycle heater/fan on. 6. For 300HF, 301HF models with oscillating feature, slide the lever on base of unit to OSCILLATION ON (C). 7. For 200HF, 201HF and BDHF200T models with a built-in digital thermometer, check thermometer to see area temperature. Depending on model, it will be displayed in either °F or °C (D). Digital thermometer runs on batteries and is not affected by whether or not the unit is plugged in. The batteries are already installed. To activate thermometer, turn unit over and pull plastic tab out of battery cover on under side of unit. To change batteries, unscrew battery cover on underside of unit and pull on the ribbons to pop old batteries out. Replace batteries with new LR44 (or AG13) cells by placing them with the flat sides (+) facing in toward each other. Replace battery cover and snap in place. Do not overtighten screw. Special features and the Advanced Safety Technology™ (AST) system 1. This unit is equipped with a safety auto off, plus a safety thermal fuse and CAUTION light. If the unit experiences excessive heat, the safety auto off will shut off unit, and CAUTION light will go on. If this happens, turn dial to OFF immediately. Be sure front and back grilles are not blocked and nothing is restricting airflow. If CAUTION light stays on, unplug unit, let it cool down, and wait 10 minutes before plugging it back in to operate. Readjust your temperature or room settings. If unit fails to operate after 10 minutes, it may mean heater has internal damage and thermal fuse has been tripped so heater can no longer operate. 2. Motion-off detection feature: Cuts the power if unit falls over in any direction or is lifted (such as...

Herunterladen

Geben Sie zwei Ziffern: