Stimmen - 3, Durchschnittliche Bewertung: 4.3 ( )

Hersteller: Blodgett Dateigröße: 3.81 mb Dateiname: Unterrichtssprache:

2. Push to choose. 3. Mini- Knob 1. Push and hold at the same time to enter/exit SF. Push to enter choice . in the display, indicating that the oven is baking/roasting. The Timed cooking feature may be used in Sabbath Mode. To use the Timed cooking feature, set the Cook Time and the temperature before entering the Special Features mode and selecting SAbbAth. The Delay start feature cannot be used in Sabbath mode. 3 Push the Mini-Knob to enter your choice. 4 Push and hold the Mini-Knob for 5 seconds to exit SF (Special Features) and return to the time of day clock. NOTE: On double oven models, this activates this special feature in both ovens. Care and Cleaning Wall Oven BE SURE ELECTRICAL POWER IS OFF AND ALL SURFACES ARE COOL BEFORE CLEANING ANY PART OF THE OVEN. Control panel and knobs Clean up spatters with a damp cloth. Remove heavier soil with warm, soapy water. Do not use abrasives of any kind on the control panel or knobs. The control knobs may be removed for easier cleaning. To remove a knob, pull it straight off the stem. Wash the knobs in soap and water but do not soak. NOTE: The Mini-Knob is not removable. Oven Do not clean the broil element. Any soil will The bake element is not exposed and is burn off when the element is heated. under the oven floor. If spillovers, residue heating or ash accumulate on the oven floor, wipe elements up before self-cleaning. Broiler pan and grid After broiling, remove the broiler pan and grid Grid from the oven. Remove the grid from the pan. Carefully pour out the grease from the pan into a Broiler pan proper container. Wash and rinse the broiler pan and grid in hot water with a soap-filled or plastic scouring pad. If food has burned on, sprinkle the grid with detergent while hot and cover with wet paper towels or a dishcloth. Soaking the pan will remove burned-on foods. The broiler pan and grid may be cleaned with a commercial oven cleaner. The broiler pan and grid can also be cleaned in the dishwasher. Do not store a soiled broiler pan or grid anywhere in the oven. CAUTION: Do not clean the broiler pan or grid in a self-cleaning oven. 34 Care and Cleaning Wall Oven Oven racks The racks may remain in the oven during the self-cleaning cycle without being damaged. Periodically, after several self-clean cycles, the oven racks may need to be lubricated using the Graphite Lubrication shipped with your wall oven. To order additional Graphite Lubrication, call our National Parts Center 800.626.2002 and reference WB02T10303. 1 Remove rack from the oven. See the Full extension oven racks section. 2 Fully extend the rack on a table or countertop. Newspaper may be placed underneath the rack for easy clean up. 3 If there is debris in the slide tracks, wipe it away using a paper towel. NOTE: Any graphite lubricant wiped away must be replaced. 4 Shake the graphite lubricant before opening it. Starting with left slide mechanism of the rack, place four (4) small drops of lubricant on the two (2) bottom tracks of the slide close to the bearing carriers. 5 Repeat for the right slide mechanism of the rack. 6 Open and close the rack several times to distribute the lubricant. 7 Replace the cap on the lubricant and shake it again. Turn the rack over and repeat steps 3, 4, 5 and 6. 8 Close the rack, turn rack right-side-up and place in the oven. See the Full extension oven racks section. 9 Repeat above steps for each rack. NOTE: Do not spray with Pam® or other lubricant sprays. Left side Left side Right side Right side Rack right-side-up Rack right-side-up Rack up-side-down Rack up-side-down Care and Cleaning Wall Oven Lift-off oven door— removal The door is very heavy. Be careful when removing and lifting the door. IndentationRemoval positionHinge lockSlot Do not lift the door by the handle. To remove the door: 1 Fully open the door. 2 Pull the hinge locks down toward the door frame, to the unlocked position. A tool, such Pull hinge locks down to unlock as a small flat-blade screwdriver, may be required. 3 Firmly grasp both sides of the door at the top. 4 Close door to the door removal position, which is most of the way and lift it up and out until the hinge arm is clear of the slot. To replace the door: Bottom 1 Firmly grasp both sides of the door at the top. edge of 2 With the door at the same angle as the slot removal position, seat the indentation of the hinge arm into the bottom edge of the hinge slot. The notch in the hinge arm must be fully seated into the bottom of the slot. Hinge arm 3 Fully open the door. If the door will not fully open, the indentation is not seated correctly in the bottom edge of the slot. 4 Push the hinge locks up against the front frame of the oven cavity, to the locked position. 5 Close the oven door. Hinge lock Hinge arm Push hinge locks up to lock Probe The temperature probe may be cleaned with soap and water or a soap-filled scouring pad. Cool the temperature probe before cleaning. Scour stubborn spots with a soap-filled scouring pad, rinse and dry. ...

Herunterladen

Geben Sie zwei Ziffern: