Stimmen - 2, Durchschnittliche Bewertung: 4 ( )

Hersteller: Thermador Dateigröße: 2.7 mb Dateiname: Unterrichtssprache:

Use all products according to package directions. Refer to oven illustration on Page 4 to identify oven parts. PART CLEANING METHOD Chrome Plated - Oven racks Wash with hot sudsy water. Rinse thoroughly and dry. Or, gently rub with Soft Scrub®, Bon-Ami® , Comet®, Ajax®, Brillo® or S.O.S.® pads as directed. Easy Off® or Dow® Oven Cleaners (cold oven formula) can be used, but may cause darkening and discoloration. If Racks are cleaned in the oven during the self-clean mode, they will lose their shiny finish and permanently change to a metallic gray. Coat rack slides lightly with vegetable oil if they do not slide well. The Extendable Rack (C oven models) should not be left in oven during self-clean. Fiberglass Knit - Door seal gasket DO NOT HAND CLEAN GASKET. Glass - Control panel - Door front Spray Windex® or Glass Plus® onto a cloth first, then wipe to clean. Use Fantastik® or Formula 409® to remove grease spatters. Painted * Clean with hot sudsy water or apply Fantastik® or Formula 409® first to a clean sponge or paper towel and wipe clean. Avoid using powdered cleansers and steel wool pads. Porcelain - Oven front frame - Oven cavity - Broil pan and grid Immediately wipe up acid spills like fruit juice, milk and tomatoes with a dry towel. Do not use a moistened sponge/towel on hot porcelain. When cool, clean with hot sudsy water or apply Bon- Ami® or Soft Scrub® to a damp sponge. Rinse and dry. For stubborn stains, gently use Brillo® or S.O.S.® pads. It is normal for porcelain to craze (fine lines) with age due to exposure from heat and food soil. Reflective Glass - Interior door window Clean with hot sudsy water and sponge or plastic scrubber. Rub stubborn stains with vinegar, Windex® , ammonia or Bon-Ami® . DO NOT USE HARSH ABRASIVES. STAINLESS STEEL - Control panel -Door front Always wipe or rub with grain. Clean with a soapy sponge; rinse and dry. Or, wipe with Fantastik® or Formula 409® sprayed onto a paper towel. Protect and polish with Stainless Steel Magic® and a soft cloth. Remove water spots with a cloth dampened with white vinegar. Use Zud®, Cameo® or Barkeeper's Friend® to remove heat discoloration. Probe Clean probe by hand with detergent and hot water. Rinse and dry. Do not soak or clean in dishwasher. * Door frame, side trim, control panel trim, oven cooling vents, door handle, door cooling vent and trim, door end caps. 29 Do-It-Yourself Maintenance Built-in Oven Care and Use Manual Do-It-Yourself Maintenance Removing the Oven Door The oven door(s) can be lifted off for your convenience in cleaning hard-to-reach areas inside the oven. CAUTION USE CAUTION WHEN REMOVING THE DOOR(S). DOORS ARE VERY HEAVY. • Make sure oven is cool and power to oven has been turned off before removing the door. Failure to do so could result in electrical shock or burns. • The oven doors are heavy and fragile. Use both hands to remove or replace the door. • Grasp only the sides of the oven door when removing or replacing it. • Failure to grasp the oven door firmly and properly could result in personal injury and product damage. • With the door off, never release the levers and try to close the hinges. Without the weight of the door, the powerful springs will snap the hinges closed with great force. To Remove the Oven Door: 1. Fully open the oven door. 2. Raise the U-clip over the hook on each of the hinges to the "locked" position (see illustration below). This will prevent the hinge from snapping closed when the door is removed. 3. Grasp the door by the sides toward the back. Raise the front of the door several inches (there will be some spring resistance to overcome because of the hinge being locked). When the front of the door is high enough, you will be able to lift the hinges to clear the indents. 4. Pull the hinges out of the slots in the oven front frame. To Replace the Oven Door: 1. Grasp the sides of the door at the center and insert the ends of the hinges into the slots in the oven front frame as far as they will go (see illustration below). 2. With the door open all the way, lower the two locking clips. 3. Raise the oven door and make sure that it fits evenly with the front sides. 4. Close and open door slowly to be sure it is correctly and securely in place. 5. Door must be straight, not out of alignment. HINGE CLIP HINGE ARM Door Hinge with lowered locking clip 30 Do-It-Yourself Maintenance Built-in Oven Care and Use Manual Do-It-Yourself Maintenance Replacing the Oven Light CAUTIONS: To prevent personal injury: • Before replacing the light bulb, be sure the electric power is turned off at the circuit breaker. • Halogen bulbs get HOT instantly when turned ON. • Be sure the oven and light bulb are cool. • Do not operate the oven unless the light cover is securely in position. CAUTION: If the light cover is damaged or broken, do not use the oven until a new cover is in place. The oven lights are located on the top ceiling wall of the oven. The lights have a removable lens cover and a halogen light bulb....

Herunterladen

Geben Sie zwei Ziffern: