Stimmen - 1, Durchschnittliche Bewertung: 4
(
)
)
|
Dieses Gerät hat auch andere Anweisungen:
Anleitung Zusammenfassung
• When you purchase the DT 18 – 55 mm F3.5 – 5.6 SAM Lens Kit, purchase the Rear Lens Cap ALC-R55 also. Note on changing the lens When changing the lens, if dust or debris gets inside the camera and lands on the surface of the image sensor (the part that acts as the film), it may appear on the image, depending on the shooting environment. The camera is equipped with an anti-dust function to prevent dust from landing on the image sensor. However, quickly change the lens away from dusty locations when attaching/removing a lens. If dust or debris lands on the image sensor Clean the image sensor using [Cleaning mode] in the Setup menu (page 33). Preparing the camera 21 Inserting a memory card Inserting a memory card 1 Open the memory card cover. 2 Insert “Memory Stick PRO Duo” Face side (SD memory card) media or an SD memory card. • Insert the memory card until it clicks as illustrated. Terminal part Face side (“Memory Stick PRO Duo”) Terminal part 3 Select the type of memory card you want to use using the memory card switch. 4 Close the memory card cover. 4 Close the memory card cover. Check that the access lamp is not lit, then open the memory card cover, and push the memory card once. Preparing the camera Access lamp Notes on using memory cards • Do not strike, bend or drop the memory card. • Do not use or store the memory card under the following conditions: – High temperature locations such as the hot interior of a car parked in direct sunlight. – Locations exposed to direct sunlight. – Humid locations or locations with corrosive substances present. • The memory card may be hot just after it has been used for a long time. Be careful when you handle it. • When the access lamp is lit, do not remove the memory card or the battery pack, or turn off the power. The data may be corrupted. • Data may be damaged if you place the memory card near strongly- magnetized material or use the memory card in a static-prone or electrically noisy environment. • We recommend backing up important data, such as to a hard disk of a computer. • When you carry or store the memory card, put it in the case supplied with it. • Do not expose the memory card to water. • Do not touch the terminal section of the memory card with your hand or a metal object. • When the write-protect switch of a memory card is set to the LOCK position, you cannot perform operations, such as recording or deleting images. 23 • • • The memory cards formatted with a computer are not guaranteed to operate with this camera. • Data read/write speeds differ depending on the combination of the memory cards and the equipment used. • Do not press down hard when you write down on the memo area. • Do not attach a label on the memory cards themselves. • Do not disassemble or modify the memory cards. • Do not leave the memory cards within the reach of small children. They might accidentally swallow it. Notes on the “Memory Stick” media used with the camera The types of “Memory Stick” media that can be used with this camera are listed in the table below. However, proper operation cannot be guaranteed for all “Memory Stick PRO Duo” media functions. “Memory Stick PRO Duo” media* Available with your camera “Memory Stick PRO-HG Duo” media* “Memory Stick Duo” media Unavailable with your camera “Memory Stick” media and “Memory Stick PRO” media Unavailable with your camera * This is equipped with MagicGate function. MagicGate is copyright protection technology that uses encryption technology. Data recording/playback that requires MagicGate functions cannot be performed with this camera. * Supports high-speed data transfer using a parallel interface. Preparing the camera Preparing the camera When you turn the camera on for the first time, the date/time setup screen appears. 1 Set the power switch to ON to turn the camera on. • To turn the camera off, set it to OFF. Preparing the camera 2 Verify that [OK] is selected on the LCD monitor, then press the center of the control button. 3 Select each item with b/B and set the numeric value with v/V. • When changing the sequence of [YYYY/MM/DD], first select [YYYY/ MM/DD] with b/B, then change it with v/V. 4 Repeat step 3 to set other items, then press the center of the control button. 25 5 Verify that [OK] is selected, then press the center of the control button. 5 Verify that [OK] is selected, then press the center of the control button. Press the MENU button. To set up the date/time again MENU button t 2 t [Date/Time setup] Using the accessories supplied Using the accessories supplied • Rechargeable battery pack (page 14) • Battery charger (page 14) • Power cord (mains lead) (not supplied in the U.S.A. and Canada) (page 14) • USB cable (pages 132, 148) •CD-ROM (page 140) Attaching the shoulder strap Attach both ends of the strap onto the camera. • You can also attach the eyepiece cover (page 28) on the strap. Eyepiece cover Preparing the camera 27 Using the eyepiece cover and eyecup Using the eyepiece cover and eyecup 1 Tilt the LCD m...
Dieses Handbuch ist für folgende Modelle:Kameras - DSLR-A330 (5.98 mb)
Kameras - DSLR-A330H (5.98 mb)
Kameras - DSLR-A330L (5.98 mb)
Kameras - DSLR-A330Y (5.98 mb)