When the air is cool with low humidity, “sweating” may not be evident. • How long has the heater been operating? During initial pool heating in cold weather, it may require a week to elevate the pool temperature to a comfortable level. Normally, it takes about 4 days. • How many hours per day is the unit operating? Remember that the heat pump only operates while the pool pump is running. Set the time clock to permit 24 hour per day 7 operation. After the desired temperature is reached, return th

WARNING Do not install the unit within 3 ft of fossil fuel burning heaters. Air intake along the sides of this heat pump could disturb the combustion process of the unit, and could cause damage or personal injury. • Mount the unit on a level, sturdy base, preferably a concrete slab or blocks. The size of the base should be not less than 3 ft by 3 ft. • Completely isolate the base from the building foundation or wall to prevent sound or vibration transmission into the building. For this purpose,

When this lamp is ON, service is required. Call the number shown in the CONTACT INFORMATION at the front of this manual. V. Initial Start-Up and Check 1. Verify that the Power lamp is ON and that the pool pump is running and circulating properly. 2. Verify that the control panel Spa-Remote-Pool switch is in the Remote (OFF) position; see the figure. 3. Turn the control switch to either Pool or Spa to turn the system ON and raise the thermostat setting above the current water temperature. At this

It activates the pump as needed to support hot water demand, and shuts the pump down only after evacuating the boiler's residual heat to the heating system or hot water storage tank. The Economaster II saves money in several ways. Electrical costs are reduced, since the pump is not running constantly. In addition, gas costs are cut, because residual heat that would otherwise escape through the flue is captured, and water is not subject to cooling during unnecessary circulation through the syste

Your results may vary. Economaster Circuit Board Catalog No.: 5100.20-I Effective: 12-28-07 Replaces: 03-15-03 ELECTRICAL DATA Adjustable Timing: 3 to 10 minutes (Factory set at 7 minutes) Input Power (Primary): 24 VAC 50/60 Hz Input Signal (Controller): 24 VAC or 120 VAC Output (SPST Relay): Load - Up to 10 Amp-120 VAC Single Phase* Ambient Temperature: -67°F to +158°F * Motors larger than 3/4 HP and three-phase current require a contactor or motor starter equipped with a 120 VAC coil

("Raypak") warrants to the original owner that all parts of this boiler which are actually manufactured by Raypak will be free from failure under normal use and service for the specified warranty periods and subject to the conditions set forth in this Warranty. Labor charges and other costs for parts removal or reinstallation, shipping and transportation are not covered by this Warranty but are the owner's responsibility. HEAT EXCHANGER WARRANTY: Five (5) years from date of boiler installation

Owners Operating Instructions Part 3: Warranty Date of Installation: // // Model No. Serial No. Installed by: Purchased from: This Installation and Operating Instructions Manual is provided with the necessary information for the proper installation, operation and maintenance of your Raypak Heater. Please review and follow these procedures carefully. Keep this manual in a safe and accessible place for easy reference in the future. 3 PART 1 - FOR YOUR SAFETY For your safety do not operate this app