Stimmen - 4, Durchschnittliche Bewertung: 3.8 ( )

Hersteller: Craftsman Dateigröße: 1.86 mb Dateiname: Unterrichtssprache:

Adjust limits and/or force it necessary. (See pages 28 and 29.) Repeat the safety reverse test. Make any necessary adjustments (See page 30). The remote control The lithium batteries should produce power for up to 5 years. To replace batteries, use the visor clip or screwdriver blade to pry open the case, as shown. (UOpen"location is stamped on back of remote 3-FUNCTION Open thls end Twist hem COMPAC to oden control case.) Insert batteries positive side down. Replace cover as follows. 3-Function remote: insert the 3 tabs at the opposite end and snap shut. Compact 3-Function remote: Snap shut along both sides. Dispose of old batteries properly. Schedule Twice a Year Check chain tension. Disconnect trolley first. Adjust if necessary (See page 11). Once a Year Oil door rollers, bearings and hinges. The opener does not require additional lubrication. Do not grease the door tracks. 31 Operation of Your Opener Activate the opener with any of the following: • The Remote Control: Hold push button down until the door starts to move. • The Door Control: Hold push button down until the door starts to move. • The Outdoor Key Switch or Keyless Entry. (See Accessories) When the opener is activated with the safety reversing sensor installed and correcUy aligned: 1. If open, the door will close. If closed, the door will open. 2. If closing, the door will reverse. 3. If opening, the door will stop (allowing space for entry and exit of pets and for fresh air). 4. If the door has been stopped in a partially open position, it will close. 5. If obstructed while closing, the door will reverse. 6. if obstructed while opening, the door will stop. 7. The garage door will reverse in the closingcycle when the invisiblebeam isbroken,iffullyopen,the doorwill notclose when the beam is broken.The sensor has no effect in the opening cycle. If the sensor is not installed or not aligned correctly, the door won't close from any remote control. You can close the door with the Door Control, the Outdoor Key Switch, or Keyless Entry, however, if you activate them until down travel is complete. If you release them too soon, the door will reverse. The opener lights will blink for 5 seconds when the safety reversing sensor causes the door to reverse. The Opener Lights will turn on under the following conditions: When the opener isinitiallypluggedin;when the power is interrupted; when the opener is activated. They will turn off automatically after 4-1/2 minutes or provide constant light when the Light feature on the Premium Control Console is activated. SECURITY,I, models: Lights will also turn on when someone walks through the open garage door. Bulb size is 75 watts maximum. Operation of the Door Weak or broken springs could allow an open door to fall (either rapidly or unexpectedly), resulting in serious injury, death or property damage. If possible, release rope and handle fully closed. Emergency Release Handle (Pull Down) Manual disconnect position The lockout feature prevents the trolley from reconnecting automatically. Pull the emergency handle down and back (toward the opener). The door can then be raised and lowered manually as often as necessary. To disengage the lookout feature, pull the emergency handle straight down. The trolley will reconnect on the next UP or DOWN operation. Controls (see page 18) use the emergency only when the door is To open the door manually: The door should be fully closed if possible. Pull down on the red emergency release handle and liftthe door manually. To reconnect the door to the opener, press the Door Control push button. O _ . Trolley Release Arm Emergency Release Handle (PullDoom& Back Towards Opener) Lockout position (SECURITY.I, models: See additional programming features, next page.) Press the lighted push button to open or close the door. Press again to reverse the door during the closing cycle or to stop the door while it's opening. Premium Console: Light feature: Press the large round Light button, if the opener light is off, it will tum on. If the opener light is on, (even in the 4-1/2 minute automatic cycle) it will turn off. But if you use the Light button to turn the lights on and then activate the opener, the lights will turn off after 4-1/2 minutes. The Light button will not control the opener lights when the door is in motion. Premium Console (cont.): Lock feature: The Lock feature is designed to prevent operation of the door from remote controls. However, the door will open and close from the Door Control, the Outdoor Key Switch and the Keyless Entry Accessories. To activate: Press and hold the small round Lock button for 2 seconds. The push button light will flash as long as the Lock feature is on. To turn off: Press and hold the Lock button again for 2 seconds.The push button light will stop flashing. The Lock feature will also turn off whenever the SRT button on the opener panel is activated. 32 Receiver and Remote Control Programming SECURITY Your garage door opener receiver and remote c...

Herunterladen

Geben Sie zwei Ziffern: