All rights reserved. Printed in USA P464800_R1:03.11 This product and its components are subject to change without notice. Section TitleWARNING! DEATH or SERIOUS INJURY can occur: WARNING! DEATH or SERIOUS INJURY can occur: • Harness mode: use only with children who weigh between 25 and 85 lbs (11.3 and 38.6 kg) and whose height is between 30 and 57 in. (76.2 and 144.8 cm) and are at least 2 years of age. • Booster mode: use only with children who weigh between 40 and 120 lbs (18.1 and 54.4 kg)

All rights reserved. This product and its components are subject to change without notice. Printed in USA P321900 WARNING! DEATH or SERIOUS INJURY can occur if the following are not observed : • Use only with children who weigh between 2.3 – 18.1 kg (5 – 40 lbs) and whose height is between 55.9 – 101.6 cm (22 – 40 in.). • Use rear-facing for children who weigh between 2.3 – 13.6 kg (5 – 30 lbs) and whose height is between 55.9 – 76.2 cm (22 – 30 in.) • Use forward-facing for children who weigh b

E). • If your vehicle is equipped with an automatic locking retractor (ALR), use of lock-offs is not required as long as ALR is activated. Check your vehicle’s owner’s manual to determine type of retractor your vehicle has, and for proper use of retractor. 8Verify all connections are secure and restraint is stable. The restraint is secure when it cannot be moved front-to-back or side-toside more than 1” (2.5 cm.) at belt path. If restraint is not secure, repeat procedure or use an alternate seat

The base can remain in the vehicle during visual inspection of carrier. Turn carrier upside down so the underside of the carrier faces upward. If one or both tabs do not fully cover the opening, contact Britax Child Safety, Inc. at 888-427-4829 for further instruction. If both tabs are not fully covered, you may continue to use the carrier in vehicle without the base. On bottom of carrier where rubber strips run along edges of support rails, there is an exposed opening with attachment hooks.

. . . . . . . WARNINGS . . . . . . . . . . . . Important Notes. . . . . . . . . . . . . . Certification . . . . . . . . . . . . . . . . . Registration . . . . . . . . . . . . . . . . . . . Vehicle Safety Belts . . . . . . . . . . . . . . . . . . . . Vehicle Seating Positions . . . . . . . . . . . . . . . . . . . . . . Features. . . . . . . . . . . . . . . . . . . . . . . . Securing the Child . . . . . . . . . . . . . . . . . . . . . . . . . . . Installation . . . . . . . . . . . . . . . . . . .

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Safety Information. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Child Restraint Features. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6–7 Vehicle Safety Belts. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Vehicle Seating Positions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . .

8 Vehicle Compatibility Incompatible Vehicle Seat Belts...................................................................................10 Vehicle Buckle Positions...............................................................................................11 Vehicle Seating Positions..............................................................................................11 Installation: Rear-Facing LATCH Installation.......................................................................

Doing so could cause the child seat not to perform as intended. Forward-Facing Installation Forward-Facing Installation 1 Loosen the harness. a Lift harness adjuster lever b Pull both harness straps forward 2 Remove the body pillow and unbuckle the harness. 3 Pull the head restraint cover up, then pull the seat cover forward to access the forward-facing belt path. 4 Route the vehicle seat belt through the forward-facing belt slots, then buckle. Ensure the vehicle belt is not twisted. 5 Push the

33IMPORTANT: • The harness buckle strap should lie toward the back of the child seat during installation. • The buckle should be in the inner slot for rear-facing installation. 34 1 Loosen the harness. a Lift harness adjuster lever b Pull both harness straps forward 2 Remove the body pillow, unbuckle the harness, and remove the belly pad. 3 Pull the head restraint cover up, then pull the seat cover forward while pulling the buckle through to access the rear-facing belt path. IMPORTANT: Ensure bu

Certification............................................................................ Registration............................................................................ Weight Range/Maximum Height............................................ Installation: Aircraft............................................................................... Features Front View.............................................................................. Rear View........................................