Stimmen - 4, Durchschnittliche Bewertung: 3.8 ( )

Hersteller: DeWalt Dateigröße: 436.19 kb Dateiname: Unterrichtssprache:

Always use correct battery pack (pack supplied with tool or replacement pack exactly like it.) Never install any other battery pack. It will ruin your tool and may create a hazardous condition. 5 English English Fan Cooling This charger is equipped with an internal of DEWALT DW0242 battery packs. The fan operation is automatic and will turn on when required during battery also cycle periodically when there is no battery to blow dust from the fan vents. WARNING: Fan may blow debris from vent area at any time. Keep face and eyes away from area above vents. To minimize the risk of eye injury, always use eye protection. Installing and Removingthe Battery Pack NOTE: Make sure your battery pack is fully charged. To install the battery pack into the tool handle, align the base of the tool with the notch inside the tool’s handle and slide the battery pack firmly into the handle until you hear the lock snap into place as shown in FIG. 1. To remove the battery pack from the tool, slide the release button (A) away from the battery FIG. 1 A B pack (B) and the battery may be removed from the tool handle. Insert it into the charger as described in the charger section of this manual. Additional Specific Safety InstructionsWhen Using DW0247 AC Adapter • Double insulated tools are equipped with a polarized plug (one blade is wider than the other.) This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install a polarized outlet. Do not change the plug in any way. Double insulation eliminates the need for the three wire grounded power cord and grounded power supply system. • Avoid body contact with grounded surfaces such as pipes, radiators, ranges and refrigerators. There is an increased risk of electric shock if your body is grounded. • Don’t expose power tools to rain or wet conditions. Water entering a power tool will increase the risk of electric shock. • Do not abuse the cord. Never use the cord to carry the tools or pull the plug from an outlet. Keep cord away from heat, oil, sharp edges or moving parts. Replace damaged cords immediately. Damaged cords increase the risk of electric shock. • When operating a power tool outside, use an outdoor extension cord marked “W-A” or “W.” These cords are rated for outdoor use and reduce the risk of electric shock. Recommended Minimum Wire Size for Extension Cords Total Length of Cord 25 ft. 50 ft. 75 ft. 100 ft. 125 ft. 150 ft. 175 ft. 7.6 m 15.2 m 22.9 m 30.5 m 38.1 m 45.7 m 53.3 m Wire Size 18 AWG 18 AWG 16 AWG 16 AWG 14 AWG 14 AWG 12 AWG • Avoid accidental starting. Be sure switch is off before plugging in. Carrying tools with your finger on the switch or plugging in tools that have the switch on invites accidents. • Disconnect the plug from the power source before making any adjustments, changing accessories, or storing the tool. Such preventative safety measures reduce the risk of starting the tool accidentally. • The label on your tool may include the following symbols. V ..........volts A..............amperes Hz ........hertz W ............watts min ......minutes ..........alternating current ......direct current no ............

Herunterladen

Geben Sie zwei Ziffern: