Stimmen - 0, Durchschnittliche Bewertung: 0
(
)
)
|
Anleitung Zusammenfassung
Note Even though the tests were conducted under standard laboratory conditions, the actual performance may deviate from these tests. The system was tested and certified on model 9000 077 095 by NSF International with reference to ANSI/NSF Standard 53 for a reduction in cysts and turbidity, as well as with reference to ANSI/NSF Standard 42 for a reduction in the taste and odour of chlorine. Nominal particle class: I Nominal service life: 2.800 litres Average Max. Max. Min. NSF test reduction as permitted waste reduction as % concentration water % in waste water Cysts * 166.500 Min. 50.000/l 1 99.99 99.95 1 99.99 51107703 Turbidity 10.7 11 x 1 NTU 0.3 l 97.10 0.5 NTU 0.49 95.42 51107803 Particle 5.700.000 At least 30.583 99.52 > 85% 69.000 98.9 511079class I 10.000 03 Particle size > 0.5 particles/ml to < 1.0 .m Taste of chlorin 1.9 2.0 mg/l + 10% 0.05 97.3 > 50% 0.06 96.84 51108103 e and turbidity * Based on the use of Cryptosporium parvum ocysts. Application guidelines / Water supply parameters: Water pressure 207 -827 kPa Water temperature * 0.6 °C -38 °C Flow rate 2.83 l/min. ¦ The system is to be installed and operated according to the guidelines recommended by the manufacturer. ¦ The filter is to be changed every 6-9 months. ¦ Rinse new filter thoroughly for 5 minutes. ¦ More detailed information can be found on the warranty card. Without appropriate disinfection before and after connecting it to the system, this product should NOT be used if the water is microbiologically contaminated or if the quality has not been ascertained. A system certified for cyst reduction should be used for disinfected water which possibly contains filterable cysts. A one-year warranty is issued for the entire system (except disposable cartridge). With reference to disposable cartridges a warranty is issued for material and processing faults only. As the service life of disposable cartridges depends on the local water conditions, no warranty is issued for them. More detailed information on the prices of spare parts is available from your appliance dealer or parts salesman on site. Manufactured by: Cuno Engineered Products 1000 Apollo Road Eagan, MN 55121-2240 U.S.A. en Interior fittings Taking out the shelves You can reposition the shelves inside the appliance and the door shelves as required. Lift the shelves and remove. Shelves inside the compartment Door shelves Containers in the freezer compartment The containers in the freezer compartment can be taken out for cleaning. 1. Lift container slightly and take out. 2. Lift container at front slightly and insert into the runners. 3. Lower container and push back. Ice cube container a=Caution A full ice cube container is heavy! Note Before removing the ice cube container, switch the ice maker off, see “Ice maker”. en Switching off and disconnecting the appliance Switching the appliance off Press the On/Off button. Pull out the mains plug. Disconnecting the appliance If you do not use the appliance for a prolonged period: 1. Before switching off, it is most important that you switch the water supply to the appliance off for a few hours. 2. Take all food out of the appliance. 3. Switch the appliance off. 4. Pull out mains plug or switch off fuse. 5. Empty and clean the ice cube container (see chapter Cleaning the appliance). 6. Clean the appliance interior (see chapter Cleaning the appliance). 7. Leave the appliance doors open to prevent odours from forming. Defrosting Defrosting is actuated automatically. Cleaning the appliance a=Warning Never clean the appliance with a steam cleaner! a=Caution ¦ Do not use abrasive, chloride or acidic cleaning agents or solvents. ¦ Do not use scouring or abrasive sponges. The metallic surfaces could corrode. ¦ Never clean shelves and containers in the dishwasher. The parts may become deformed! Proceed as follows: 1. Before cleaning: Switch the appliance off. 2. Pull out mains plug or switch off fuse. 3. Take out the frozen food and store in a cool location. Place the ice pack (if enclosed) on the food. 4. Clean the appliance with a soft cloth, lukewarm water and a little pH neutral washing-up liquid. The rinsing water must not run into the light. 5. Wipe the door seal with clear water only and then wipe dry thoroughly. 6. After cleaning reconnect and switch the appliance back on. 7. Put the frozen food back in the freezer compartment. Interior fittings All variable parts of the appliance can be taken out for cleaning (see chapter Interior fittings). Cleaning the ice cube container If ice cubes have not been dispensed for a prolonged period, they will shrink, have a stale taste and stick together. Therefore, the ice cube container should be cleaned regularly. a=Caution A full ice cube container is heavy. 1. Remove the ice cube container. 2. Pull out the container, empty and clean with lukewarm water. 3. Rub the container and screw conveyor dry so that new ice cubes cannot freeze to them. 4. Insert ice cube container and push back until it engages...
Dieses Handbuch ist für folgende Modelle:Kühlen - FI18NP31/11 (6.69 mb)
Kühlen - FI18NP31/12 (6.69 mb)
Kühlen - FI24NP31/12 (6.69 mb)