Stimmen - 4, Durchschnittliche Bewertung: 3.8 ( )

Hersteller: AEG Dateigröße: 436.19 kb Dateiname: Unterrichtssprache:

With the last turn align the mixing valve in such a way that the flow control screw is pointing downwards. Attach the swivel spout to the underside of the mixing valve by means of the cap nut. Fitting the water container Push the cap nut of the pinch-type fitting, together with the washer and the expanding seal, onto the inlet and outlet tube of the water container. Attach the inlet and outlet tubes of the appliance to the mixing valve, at the same time guiding the screws of the rear angle bracket into the oblong holes of the wall mounting bracket. The wall clearance and the vertical position of the appliance can be adjusted by means of the oblong holes. Once adjustment has been made, tighten the screws of the wall mounting bracket and the cap nut of the pinch-type fitting. ' ' 11 Fitting the overflow pipe Slide the fixing bush over the end of the overflow pipe. Push the overflow pipe onto the outlet pipe which protrudes from the appliance housing and secure by pressing in the retaining rings. Setting the flow control screw In cases where the water pressure is extremely high, the inlet flow of the cold water can be reduced by means of the flow control screw. Turn the screw in the direction marked „closed“. The cold water supply can be shut off completely by setting the slot of the flow control screw exactly at right angles to the direction of flow. Maximum flow rate is obtained by setting the slot of the flow control screw in line with the direction of flow. In order to clean the flow control valve, turn the screw through an angle of 180 ° and flush thoroughly. 2.5 Electrical connection The electrical connection must not be carried out until the appliance has been properly connected to the water supply. When effecting the electical connection pay particular attention to the requirements of your local electricity supply authority and any other generally applicable regulations (in Germany: VDE 0100). The water heater is supplied with a connection lead of a length of approx. 0.5 m which is fitted with an earthed safety plug. It ist advisable to provide the applicae with a separate electrical circuit. 2.6 Initial operation and control Initial operation of the water heater must be carried out by a suitably qualified person who is responsible for ensuring that the work is done correctly and who can explain to the user how the appliance must be operated. Correct operation should be ascertained during initial operation. Important: Possible dirt and residues resulting from installation should be removed prior to initial operation by flushing the appliance thoroughly. Then fill the appliance with water, bring it to the boil and then flush it a second time. After installing the appliance please hand this instruction manual to the user! 12 3. After-sales service Complaints which arise through failure to observe these instructions cannot be acknowledged! Any faults which are not mentioned in this instruction manual must be referred to our af-ter-sales service department. The list of addresses can be obtained from the guarantee conditions which accompany the unit. It is essential that you state the model designation and the E-Number given on the nameplate in order to avoid unnecessary queries. Wiring diagram for Thermofix E Q = ON button for B 1 H1 = Indicating lamp, H 2 = Buzzer E = Heating element X = Terminal board - 2-pole - inside appliance B1 = Temperature selection limiter B2 = Steam regulator B3 = Temperature control Wiring diagram for Thermofix EL/GL 13 Universal-Wandaufhangung Universal wall bracket 14...

Herunterladen

Geben Sie zwei Ziffern: