Stimmen - 3, Durchschnittliche Bewertung: 3 ( )

Hersteller: AEG Dateigröße: 436.19 kb Dateiname: Unterrichtssprache:

The chromiumplated parts may also be cleaned with a suitable cleanser. 1.4 Maintenance of appliance Decalcifying Important: Regular decalcifying ensures troublefree operation. Use only liquid decalcifying agents, e.g. Cillit decalcifier. Fill the appliance with 1 litre of water and heat to approx. 50 °C (beginning of the second white line on the temperature selection dial). Remove the cap (13) and stopper from the top of the container and pour in 50 - 100 ml of decalcifying agent depending on the amount of furring. Replace the stopper and cap and allow the decalcifying agent to take effect for approx. 30 minutes. Then fill the container to the 5 litre mark and reheat to 50 °C. Leave the appliance for a further 30 minutes and then flush thoroughly with cold water, making sure that the water can escape freely through the overflow pipe. Now empty the appliance and re-flush with fresh water. Caution! Concentrations of water-softener above the permitted level can damage or even destroy the container seal! Please do not use vinegar. 2. Important notes on installation 2.1 General All AEG water heaters are manufactured and tested in accordance with pertinent VDE regulations and DIN standards. They have been passed as safe in accordance with the German laws on technical equipment and bear the interference suppression sym- bol, din ¡n compliance with DIN 44536 and also the ’splashproof symbol’. When instal- ling the appliance, please observe the technical data given on the nameplate as well as the technical requirements of your local electricity and water boards. 10 2.2 Technical features The water heater is equipped with a 5 litre water container and a three-way mixing valve which ist fitted with a G V2 A (R V2) connecting thread. The appliance may be used only as an open, non-pressurized unit. Thermofix E: Enamelled steel water container. Automatic switch-off in the „warnjt“ and „hot“ temperature ranges and continuous heating in the „boiling“ range. Thermofix EL: Enamelled steel water container. Automatic switch-off in the „warm“ and „hot“ temperature ranges. In the „boiling“ range the appliance switches itself off automatically and switches itself on again when the temperature drops below boiling point. Thermofix GL: Glass water container, temperature control as on Thermofix EL. 2.3 Installing the appliance The water heater should be installed only in a room which is free from frost. If the appliance is nevertheless exposed to frost, make sure that it is completely emptied. Securing the wall mounting bracket Using the mounting template supplied, mark the positions of the screwholes for fixing the wall mounting bracket. Now fix the bracket to the wall by means of wall plugs and suitable woodscrews, making sure that the bracket is perfectly horizontal. The oblong holes permit lateral and vertical adjustment. Important! If the water heater is to replace an appliance of another make, you can use a universal wall suspension bracket which is available as an accessory (E-N0. 612 899 300, illustration on page 14). If this wall suspension bracket is used, there will be need to drill new mounting holes. Fitting the three-way mixing valve The mixing valve is fitted with a DIN ISO 288 G V2 A thread for connection to the water supply. The thread must be properly wound with hemp or silicon sealing tape. Slide the cover plate over the water pipe and then, using a suitable open-ended wrench, screw the mixing valve into the water pipe. With the last turn align the mixing valve in such a way that the flow control screw is pointing downwa...

Herunterladen

Geben Sie zwei Ziffern: