Stimmen - 3, Durchschnittliche Bewertung: 4.7
(
)
)
|
Anleitung Zusammenfassung
The use of unauthorized substitutes may result in fire, electric shock, or other hazards. 3 SAFETY CHECK AFTER SERVICING After unit is serviced or repaired, request that a through safety check be done as described in the manufacturer’s service literature to insure video unit is in safe operating condition. OUTDOOR ANTENNA INSTALLATION 1 SAFE ANTENNA AND CABLE CONNECTION An outside antenna or cable system must be properly grounded to provide some protection against built up static charges and voltage. Section 810 of the National Electrical Code, ANSI/NFPA 70 (in Canada, part 1 of the Canadian Electrical Code) provides information regarding proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna discharge unit, connection to grounding electrodes, and requirements for the grounding electrode. 2 KEEP ANTENNA CLEAR OF HIGH VOLTAGE POWER LINES OR CIRCUITS Locate an outside antenna system well away from power lines and electric light or power circuits so it will never touch these power sources should it ever fall. When installing antenna, absolutely never touch power lines, circuits or other power sources as this could be fatal. GROUND CLAMP ELECTRIC SERVICE EQUIPMENT ANTENNA LEAD IN WIRE ANTENNA DISCHARGE UNIT (NEC SECTION 810-20) GROUNDING CONDUCTORS (NEC SECTION 810-21) GROUND CLAMPS POWER SERVICE GROUNDING ELECTRODE SYSTEM (NEC ART 250, PART H) NEC - NATIONAL ELECTRICAL CODE For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@panasonic.com Safety Precautions/Mesures de securite Warning : To prevent fire or shock hazard, do not expose this equipment to rain or moisture. Caution : To prevent electric shock, match wide blade of plug to wide slot, fully insert. Avertissement :Afin de prevenir tout risque d’incendie ou de chocs electriques, ne pas exposer cet appareil a la pluie ou a une humidite excessive. Attention :Pour eviter les chocs electriques, introduire la lame la plus large de la fiche dans la borne correspondante de la prise et pousser jusqu’au fond. This video recorder, equipped with the HQ (High Quality) System, is compatible with existing VHS equipment. Only use those tapes with the mark. It is recommended that only cassette tapes that have been tested and inspected for use in 2, 4, 6, and 8 hour VCR machines be used. This television receiver provides display of television closed captioning in accordance with §15.119 of the FCC rules. FCC WARNING : Any unauthorized changes or modifications to this equipment would void the user’s authority to operate. This symbol warns the user that uninsulated voltage within the unit may have sufficient CAUTION RISK OF ELECTRIC SHOCK magnitude to cause electric shock. Therefore, DO NOT OPEN it is dangerous to make any kind of contact CAUTION: TO REDUCE THE RISK with any inside part of this unit. OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK) This symbol alerts the user that important NO USER-SERVICEABLE PARTS INSIDE REFER SERVICING TO literature concerning the operation and QUALIFIED SERVICE PERSONNEL maintenance of this unit has been included. Therefore, it should be read carefully in order to avoid any problems. 4 For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@panasonic.com Before Using Cover the hole with cellophane tape. To record again.PLAY/REPEAT on the unit for 7 seconds to deactivate the SELFDEMO Mode. Repeat this to display demo screen. Congratulations on your purchase of one of the most sophisticated Loading the Batteries and reliable products on the market today. Used properly, it will bring you and your family years of enjoyment. Please fill in the information below. The serial number is on the tag located on the back of your unit. Date of Purchase Dealer Purchased From Dealer Address Dealer Phone No. Model No. Serial No. Batteries 2 “AA” Accessories To order accessories, call toll free 1-800-332-5368. Remote Control LSSQ0283 (VV-1301/VV-13F1/ VV-2001) LSSQ0284 (VV-1311W) SELF-DEMO Mode With Power ON, press 1) Open the cover. 2) Insert batteries as marked. 3) Close the cover. Battery replacement caution • Do not mix old and new batteries. • Do not mix alkaline with manganese batteries. Prevent Accidental Tape Erasure Break off the tab to protect. Record Tab Screw driver Table of Contents Table of Contents Important Safeguards and Precautions / Safety Precautions ........ 2 Before Using......................................................................................... 4 Table of Contents ................................................................................ 5 Location of Controls............................................................................ 6 Initial Setup for ANT. / Cable Connection ......................................... 8 Initial Setup for DSS / Cable box Connection..................................10 Reset Language, Channels, Clock, Tim...