Stimmen - 4, Durchschnittliche Bewertung: 3.5
(
)
)
|
Dieses Gerät hat auch andere Anweisungen:
Anleitung Zusammenfassung
Battery pack DC IN jack DC plug Power cord (Mains lead) CHG (charge) lamp AC Adaptor GB 10 . .s . You cannot attach any “InfoLITHIUM” battery pack other than the V series to your camcorder. 1 Turn off your camcorder by closing the LCD screen. 2 Attach the battery pack by sliding it in the direction of the arrow until it clicks. 3 Connect the AC Adaptor and the power cord (mains lead) to your camcorder and the wall outlet (wall socket). . Align the . mark on the DC plug with that on the DC IN jack. The CHG (charge) lamp lights up and charging starts. The CHG (charge) lamp turns off when the battery pack is fully charged. 4 When the battery is charged, disconnect the AC Adaptor from the DC IN jack of your camcorder. . Tips . See page 57 on recording and playing time. . When your camcorder is on, you can check the approximate amount of remaining battery power with the remaining battery indicator at the upper left on the LCD screen. Charging time Approximate time (min.) required when you fully charge a fully discharged battery pack. Battery pack Charging time NP-FV30 (supplied) 115 NP-FV50 155 NP-FV70 195 NP-FV100 390 . Times measured with the camcorder at 25 .C (77 °F). 10 .C to 30 .C (50 °F to 86 °F) is recommended. Getting GB To remove the battery pack Close the LCD screen. Slide the BATT (battery) release lever (.) and remove the battery pack (.). To remove the battery pack Close the LCD screen. Slide the BATT (battery) release lever (.) and remove the battery pack (.). Make the same connections as “Step 1: Charging the battery pack.” Even if the battery pack is attached, the battery pack is not discharged. Charging the battery pack abroad You can charge the battery pack in any countries/regions using the AC Adaptor supplied with your camcorder within the AC 100 V - 240 V, 50 Hz/60 Hz range. Notes Do not use an electronic voltage transformer. . . Notes on the battery pack . . When you remove the battery pack or disconnect the AC Adaptor, close the LCD screen and make sure that the POWER lamp (p. 13), the access lamp (p. 18) are turned off. The CHG (charge) lamp flashes during charging under the following conditions: . . . . The battery pack is not attached correctly. The battery pack is damaged. The temperature of the battery pack is low. Remove the battery pack from your camcorder and put it in a warm place. The temperature of the battery pack is high. Remove the battery pack from your camcorder and put it in a cool place. . In the default setting, the power turns off automatically if you leave your camcorder without any operation for about 5 minutes, to save battery power ([A.SHUT OFF]). Notes on the AC Adaptor . . . Use the nearby wall outlet (wall socket) when using the AC Adaptor. Disconnect the AC Adaptor from the wall outlet (wall socket) immediately if any malfunction occurs while using your camcorder. Do not use the AC Adaptor placed in a narrow space, such as between a wall and furniture....
Dieses Handbuch ist für folgende Modelle:Kameras - DCR-SX15E (2.8 mb)
Kameras - DCR-SR15E (2.8 mb)
Kameras - DCR-SR20E (2.8 mb)