Stimmen - 2, Durchschnittliche Bewertung: 3.5
(
)
)
|
Anleitung Zusammenfassung
Check entire box and inside all packing material for parts. Before beginning assembly, read the instructions and identify parts in this document. Proper and complete assembly, use and supervision is essential for proper operation and to reduce the risk of accident or injury. A high probability of serious injury exists if this system is not installed, maintained, and operated properly. During assembly, if using a ladder use extreme caution. Two people are recommended for this operation. If technical assistance is required, contact Huffy Sports’ Sample and Display Technician. Serious injury could occur if teeth/face come in contact with backboard, net or rim. Display recommended for 3” (7.6 cm) or 3-1/2” (9 cm) Round or 4” (10 cm) Square poles only. All instructions and warnings MUST accompany any display item that is sold. Most injuries are caused by misuse and/or not following instructions. Use caution when installing this unit. REQUIRED TOOLS AND MATERIALS: Wrenches: (Two each) 7/16”, 1/2”, 9/16", and 3/4” or Pliers Step Ladder, 8 ft. (2.4 m) IMPORTANT! To ensure prompt and correct handling of any problems, or to answer any questions, please contact the Sample and Display Technician at 1-800-558-5234. Internet Address: 1 P/N 211678A 06/03 PARTS LIST Item Qtv. Part No. Description 1 1 901097 Extension Arm 2 1 207103 Pole Cap for 3.5” Pole Section 3 2 203100 Nut, Hex Flange 5/16-18* 4 2 201611 Bolt, Hex Flange, 5/16-18 x 3” 5 4 203218 Washer, Flat, 5/16* 6 2 200516 Bolt Cover, Vinyl* 7 1 908812 3.5” Pole Section 8 4 202460 Saddle Clamp 9 4 201763 Bolt, Carriage, 3/8-16 x6.5” 10 4 203063 Locknut, 3/8 -16 11 1 204290 Spider Net P/N 211678A 06/03 2 FRONT The side with pegboard on the top and bottom. 3 P/N 211678A 06/03 Install pole mounting hardware and pole for each assembly. AWARNING TWO PEOPLE ARE NECESSARY TO MOUNT THE ELEVATOR ASSEMBLY TO THE POLE. ONE PERSON SHOULD NOT ATTEMPT TO DO THIS ALONE. FRONT P/N 211678A 06/03 4 INSTALLATION DIAGRAM Assemble display products per diagram below. AWARNING TWO PERSON MINIMUM REQUIRED FOR THIS PROCEDURE. NOT FOLLOWING RECOMMENDATION MAY RESULT IN BODILY INJURY. 48” Rectangle Steel 44” Rectangle Steel Framed Framed Acrylic Acrylic 5 P/N 211678A 06/03 s Mount extension arm and rim to backboard and finger tighten as shown. NOTE: For spring loaded rim assembly, refer to instructions included with rim hardware. P/N 211678A 06/03 6...