Stimmen - 3, Durchschnittliche Bewertung: 4.3
(
)
)
|
Anleitung Zusammenfassung
• Use a soft cloth with appliance of alcohol when polishing the scale. • Keep out water or any liquid-type substance from the scale. • Check to see if the scale is placed horizontally before use. If the scale is not in a horizontal position, use the horizontal positioning screw in order to adjust its position. (Have the foam inside of the level gauge be in the center. ) • When the scale is turned on, the display will be set to initial scaling condition after indicating RB-XX. In order to maintain its electrical safeties, warm up the machine for approximately 10 minutes before use. • Make sure the weight display is set to " 0 g " before use. If the display is not set to " 0 g ", use after setting the display to " 0 g " by pu • Use only authorized adapter. • Use same kinds of batteries when using batteries. • Remove the battery from the scale if not using the scale for a long time. It may cause damage to the scale from the leak of zinc-air battery. • Weighing by over maximum capacity may cause damage to the scale. • This scale needs periodical inspection every two years. • Never reorganize, repair or disassemble this scale. Inquire of a manufacturer of a distributor about after service. g t "Zero/Tare" key. 3. Name of Each Part N- type P-type 4. Instructions classified by Power Source 1. Adapter - Connect the adapter (DC 12V, 300mA) with the power cord. Connect the jack to the adapter jack in the back side of scale body. - Use only authorized adapter. Using a different adapter may cause a problem to the scale. - When connecting adapter while the battery is in the scale, the battery power will be automatically turned off and adapter power will be charged even though the battery is in the scale. 2. Battery ( D-size) - Open the battery cover. Place 6 units of batteries to polarity at the bottom of the scale. Close the cover properly. - Exchange the battery when “ BAT” is indicated in the display. - Not available to accurately weigh during “BAT” state. - Use same kinds of batteries when using batteries. Using different batteries may cause a problem to the scale. 3. Rechargeable battery - Put the rechargeable battery pack into the bottom of the scale after opening the battery cover. - Put the 2 pin connector from rechargeable battery pack into the power pack. - Must connect adapter jack directly from the pack case or connect adapter jack to its power pack to charge. 5. Keypad & Display Information KEY KEY NAME FUNCTION [ ] Preset Keys (PLU keys) Inputs unit price or calls up the unit price. [ 0 ] ~ [ 9 ] , [ • ] Number Keys Inputs data. M ] Save Key Saves unit price into a preset key. (Register 20 numbers of products. ) [ Unit Wt. ] Unit weight Key Sets up the unit weight of the scaled product [ Q’ty ] Quantity Key Sets up the quantity of the scaled product [ + ] Add Key Adds up the prices. = ] Total Key Shows the total add-up price. [ Tare ] Tare Key Sets up the tare or deletes the tare. [ C ] Delete Key Deletes inputted data. [ Zero ] Zero Key Sets the weight to “0g”. [ ON/OFF ] Power Key Turns the scale on/ off. C 654 .U 2 31 0 OFF 8 M 97 .. .« ON TARE Uni t Wt . Q't y ZERO 6. Function ¦ Procedures to set to Zero • Used in order to set the weight display to “ 0 g” when it is not set to “ 0 g” even though there is noting on the platform. ¦ Procedures to Set...
Dieses Handbuch ist für folgende Modelle:Waagen - E15CB (552.95 kb)
Waagen - E30CBB (552.95 kb)
Waagen - E3CB (552.95 kb)
Waagen - E6CB (552.95 kb)