Stimmen - 2, Durchschnittliche Bewertung: 3.5 ( )

Hersteller: Air King Dateigröße: 978.31 kb Dateiname: 264900EN.pdf Unterrichtssprache:

12) 35 Proceed as follows to remove and change my activated carbon filter: Switch of the fan motor by pressing the [o] button. Take the precaution of removing my cartridge fuses from their fuse holder^ or tripping my automatic circuit breaker to ensure the fan motor cannot be switched on accidentally. 1. Remove the grille (Fig. 13). — Open my latch L and swing the grille downwards. — To remove the grille, pull it forwards from the right and release it. 2. The activated carbon filter should under absolutely no circumstances ever be washed. To remove it, press the two red buttons B and pull it down and out (Fig. 14). 3. Clean the inner housing using a hot detergent solution only (never use caustic detergents, abrasive powders or brushes). 4. Fit the new activated carbon filter in its special frame, inserting the back end first and then pushing the front into place before finally locking it into position using the lock devices (red buttons, Fig. 14, B) on the activated carbon filter (Fig. 14, C). 5. Screw the fuses back in or reset the automatic circuit breaker. 6. Proceed as follows to reset the filter saturation display (counter). Select any fan speed using my [©] E or [®| F buttons and then press the [o] B and [©] F buttons at the same time, continuing to hold them down for at least 3 seconds until the flashing letter C stops being shown on the display (D) and then press the [o| button B. The activated carbon filter display is now ready for use again. Display warning on saturation of metal grease filter (Fig. 15) After 30 operating hours the letter (F- grease filters) will flash on and off on the display (D) in alternation with the fan speed setting. [ D I o ■ i [j SB 115 I This means that the metal grease filters need to be cleaned! (This operation should be carried out every 30 operating hours!) Proceed as follows to remove and clean the metal filters: Switch of the fan motor by pressing the [o] button. Take the precaution of removing my cartridge fuses from their fuse holders or tripping the automatic circuit breaker to ensure the fan motor cannot be switched on accidentally. 1. Remove the grille (Fig. 16). — Open my latch L and swing the grille downwards. — To remove the grille, pull it forwards from the right and release it. Remove the metal filter by operating the stops that fix them to the grille. 38 2. Clean the inner housing using a hot detergent solution only (never use caustic detergents, abrasive powders or brushes). 3. Leave the metal grease filter panel to soak for approximately 1 hour in very hot water with grease-dissolving detergent and then rinse it with very hot water. Repeat the operation if necessary. Load the grease filter panel in a dishwasher, selecting the most intensive washing programme and maximum temperature, at least 65°C. Repeat the operation if necessary. 4. When both metal grease filters have been cleaned and left to dry, replace them by following the above operations in reverse orde...

Herunterladen

Geben Sie zwei Ziffern: